FLUID HAMMER ARRESTORS Installation Instructions
Precision Plumbing Products
“Specify with Confidence - Install with Pride”®
INSTALLATION FLUID HAMMER ARRESTORS
www.pppinc.net
1. Flush line prior to installation. RECOMMENDED ROUGH-IN OF PPP
WATER HAMMER ARRESTORS.
2. Only use teflon tape to seal the pipe thread.
3. To tighten place wrench on hex only. Arrestors should always be installed so that
there is an unobstructed shock path to the
4. For best results locate arrestor as close to the
arrestor. Doing otherwise could result in shake
quick closing valve as possible. and rattle of the pipes when the valve is closed.
5. Either a verticle or horizontal installation is acceptable.
Arrestors should always be placed as near to
6. See product catalog for recommended pressure rating. the source of shock as possible - one each on
7. Failure to follow these instruction will make null and the hot and cold water lines.
void the product warranty.
Precision Plumbing Products of Portland, Oregon (USA) warrants our manufactured products to be free
from defects and workmanship under normal use and service. The sole and exclusive remedy for our
manufactured products that do not conform to this limited and express warranty and our sole obligation
under this limited and express warranty is to replace the defective part or product during the three year pe-
riod after original installation. This warranty excludes any parts or products that are modified or improperly
installed or installed where PH levels, chemical conditions or electrolysis prematurely degrade the product.
We specifically disclaim any warranties or responsibility for defects due to quality, material, dimensional
tolerances or quality control of any fitting or other third party supplied parts or components. EXCLUSIONS
OF ALL OTHER WARRANTIES INCLUDING IMPLIED WARRANTIES: All other warranties, including the
implied warranties of MERCHANTABILITY and fitness for a particular purpose, are EXCLUDED from this
transaction and shall not apply to goods sold by us. The above warranties are in lieu of all other warranties
and representations, express or implied, and all other obligations or liabilities on our part. We shall not be
liable for consequential damages, loss of profit, interruption of business or any other special, incidental,
or punitive damages suffered or sustained by Customer. Any part or products being returned under this
warranty must have prior authorization by us. Any part or product received by us without a return of goods
authorization will be returned to the shipper. All returned merchandise must be prepaid by shipper. Our
personnel, including salespeople, as well as independent distributors and sales agents may have made
oral statements about our products. Those statements are not warranties by us and should not be relied
on by the buyer/customer/user. If you use this product you are agreeing to this warranty contract between
us. This writing constitutes the final expression of the parties and is the complete and exclusive statement
of that contract for warranties. Rev 05/09
Precision Plumbing Products
Division of JL Industries, Inc.
802 SE 199th Ave.
Portland, Oregon 97233
T (503) 256-4010
F (503) 253-8165 MI-WHA-05 Rev 06/09
www.pppinc.net
FLUID HAMMER ARRESTORS Recommended Location of Arrestors
Precision Plumbing Products
®
RECOMMENDED LOCATION OF ARRESTORS IN A SYSTEM
Optional horizontal installation of PPP Water Hammer Arrestors
(Consult factory).
Precision Plumbing Products
Division of JL Industries, Inc.
802 SE 199th Ave.
Portland, Oregon 97233
T (503) 256-4010
F (503) 253-8165
www.pppinc.net Rev 12/14
