Scribd
Upload
330 views2 pages

D107-008 Time Sync Quick Start Rev 1.1

This quick start guide provides instructions for installing and configuring an Aparian Time Sync module. It outlines connecting a GPS antenna, powering on the module, assigning it an IP address using the Aparian Slate software, and downloading a configuration to enable it to operate as an NTP and PTP time server without additional setup. Technical support is available on the Aparian website or by email.

Uploaded by

abdel taib
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
330 views2 pages

D107-008 Time Sync Quick Start Rev 1.1

This quick start guide provides instructions for installing and configuring an Aparian Time Sync module. It outlines connecting a GPS antenna, powering on the module, assigning it an IP address using the Aparian Slate software, and downloading a configuration to enable it to operate as an NTP and PTP time server without additional setup. Technical support is available on the Aparian website or by email.

Uploaded by

abdel taib
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Revision 1.

1
06/2020

Time Sync
Quick Start Guide
A-TSM/B

REQUIRED SOFTWARE
The Time Sync module requires Aparian Slate software to setup and configure. The
software installation can be found at www.aparian.com/software/slate.

MODULE INSTALLATION
1. Mount GPS Antenna in a position with a clear view of the sky.
2. Place GPS antenna Attached GPS Antenna to SMA Connector.
3. Connect module to Ethernet Network by plugging cable into Ethernet port.
4. The Time Sync module requires input power of 10-28Vdc. The wiring of the power
connector can be found in the wiring diagram below. Power up the module.

NETWORK SETUP
1. Launch the Aparian Slate Configuration Software. Select the DHCP Server under
the Tools menu. DHCP is enabled as factory default.
2. Click the Assign button and set the IP Address. Row turns green if successful.

Document No. D107-008 Page 1 of 2


Revision 1.1
06/2020

3. Additional configuration can be set using the Target Browser also under the Tools
menu. Right click on the module in the Target Browser a select Port Configuration.

MODULE CONFIGURATION
Once the module has been assigned an Ethernet address the module will be ready to
run as a PTP and NTP time server without any further configuration. Additional
configuration can be achieved using the Aparian Slate utility.
1. In Slate start a new project under File, New.
2. Add the device by selecting Add under the Device menu, and choosing the Time
Sync Module.
3. The Configuration form open automatically. Fill in Name, Description, IP Address,
and Major Revision.
4. Set the Primary Mode, Speed Profile, and any additional options on the advanced
tab. Click OK.
5. Download the configuration to the module by right clicking the module in the
Project Explorer and selecting Download. Save the Project.

ADDITIONAL INFORMATION
Resource Link
Slate Installation www.aparian.com/software/slate
Time Sync User Manual
Time Sync Datasheet http://www.aparian.com/products/timesync
Example Code & UDTs

SUPPORT
Technical support will be provided via the Web (in the form of user manuals, FAQ,
datasheets etc.) to assist with installation, operation, and diagnostics.

For additional support the user can use either of the following:
Contact Us web link www.aparian.com/contact-us
Support email [email protected]

Document No. D107-008 Page 2 of 2

You might also like