Scribd
Upload
92 views1 page

Issue B Exhibit No. 4-6 Dated - 18-11-2011 Cir Seam

This inspection report from Raj Engineering Co. documents the inspection of a circular seam setup. The report includes details of the client, equipment information, measurements of the seam circumference and alignment offsets compared to specifications. Measurement instruments used include measuring tapes up to 15 meters and a steel rule up to 300mm. Space is allotted to record total alignment and length if inspecting multiple circular seams, and signatures are included for Raj Engineering and the client to sign off.

Uploaded by

Ganesh Yadav
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
92 views1 page

Issue B Exhibit No. 4-6 Dated - 18-11-2011 Cir Seam

This inspection report from Raj Engineering Co. documents the inspection of a circular seam setup. The report includes details of the client, equipment information, measurements of the seam circumference and alignment offsets compared to specifications. Measurement instruments used include measuring tapes up to 15 meters and a steel rule up to 300mm. Space is allotted to record total alignment and length if inspecting multiple circular seams, and signatures are included for Raj Engineering and the client to sign off.

Uploaded by

Ganesh Yadav
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

RAJ ENGINEERING CO.

H - 1 Additional Murbad Industrial Area,


Village Kudavali, MIDC, Murbad, Maharashtra - 421401.
Phone : 02524 - 225929. E-mail : [email protected]

INSPECTION REPORT ( CIRCULAR SEAM SETUP )


CLIENT: DATE:
P.O. NO.: MFR. SR. NO.
DRG. NO. EQPT. TAG NO.:
ITP NO.: EQPT. DES.
ALIGNMENT
O/S CIRCUMFERENCE AT C/SEAM ALIGNMENT
CIRCULAR SEAM SETUP WELD SEAM
SR. NO. DETAIL TOTAL LENGTH (OFFSET (OFFSET JOINT DETAIL NO. REMARKS
FIRST ITEM SECOND ITEM SPECIFIED AS OBSERVED)
PER UW-33)

MEASURING INSTRUMENT USED.


1) MEASUREMENT MEASURED BY MEASURING TAPE (RANGE – 0-5 METER, ID NO.: 5 MTR-01).
2) MEASUREMENT MEASURED BY MEASURING TAPE (RANGE – 0-15 METER, ID NO.: 15 MTR-01).
3) MEASUREMENT MEASURED BY STEEL RULE (RANGE – 0-300 MM, ID NO.: 401 C8).

NOTES:
A) TOTAL ALIGNMENT (IF MORE THAN ONE CIRCULAR SEAM OFFERED AT A TIME) =
B) TOTAL LENGTH (IF MORE THAN ONE CIRCULAR SEAM OFFERED AT A TIME) =

For RAJ ENGG. CO For A. I. / T.P.I. / CLIENT


(Name / Sign / Date) (Name / Sign / Date)
ISSUE B, Exhibit No :- 4-6 Rev. No. 0, Dated : 18. 11. 2011

You might also like