D E N O Hi-Fi Integrated Stereo Amplifier
SERVICE MANUAL
MODEL PMA-1055R
INTEGRATED STEREO AMPLIFIER
— TABLE OF CONTENTS —
‘SAFETY PRECAUTION 2
‘SPECIFICATIONS 2
DISASSEMBLY 34
BLOCK AND LEVEL DIAGRAM 5
‘ADJUSTMENT. 6
‘SEMICONDUCTORS 78
PRINTED WIRING BOARD. ott
NOTE FOR PARTS LIST 12
PARIS LIST OF P.W.8. UNIT ASS res
PARTS LIST OF EXPLODED VIEW 16
EXPLODED VIEW. : 7
WIRING DIAGRAM 18
SCHEMATIC DIAGRAM 19
PACKING VIEW 21
PARTS LIST OF PACKING & ACCESSORIES 21
¢ Some itutrations using in this service manual ar slighty ferent from the actual set. |
NIPPON COLUMBIA CO, LTD.SERED PIMA. 105 53a ERS ee ES SESE EAT
SAFETY PRECAUTIONS
LEAKAGE CURRENT CHECK
Before returning the unit tothe customer, make sure you
Power cord is less than 460 kohms, the unit is defective,
‘The following check should be performed for the continued protection of the customer and service technician.
resistance check. I the leakage current exceeds 0.5 milliamps, or if the resistance from chassis to either side of the
make either (1) a leakage current check or (2) line to chassis
SPECIFICATIONS
POWER AMPLIFIER SECTION
Rated Output Power:
Both channel driven 8Q/ohms Loads
4 Qlohms Load:
Total Harmonic Distortion:
PRE AMPLIFIER SECTION
Rated Output:
Input Sensitivity/input impedance:
PHONO:
CD, TUNER, DVDIAUX, TAPE-1/DAT, TAPE-2MD:
RIAA Deviation:
PHONO:
OVERALL CHARACTERISTICS
‘SN Ratio (IHF A Network):
PHONO:
SOURCE-DIRECT:
CD, TUNER, DVD/AUX, TAPE-1/DAT, TAPE-21MD:
Frequency Response:
‘Tone Control Adjustable Rang
BASS:
TREBLE:
LOUNDNESs:
OTHERS
Power Supply:
AC Outlets:
‘Switched x 3:
Power Consumption:
Dimensions:
Net Mass:
REMOTE CONTROL UNIT (RC-843)
Remote Control System:
Power Supply:
External dimensions:
Mass:
* Maximum dimensions include controls, jacks, and covers,
(W) = width, (H) = height, (D) = depth
65 W +65 W (20 Hz to 20 kHz, TH.D.0.07 %)
120 W + 120 W (DIN, 1 kHz, TH.D.0.7 %)
0.01 % (-9 dB at rated output, 8 Q/ohms) (1 kHz)
150 mV (Recout terminal)
2.5 mVI47 kOlkohms
150 mV/47 kOvkohms
20 Hz to 20 kHz 10.5 dB
86 dB (at 5 mV input) (input terminals short-circuited)
oN
107 48
SHz to 100kH2 +0, ~36B
100 Hz +8 4B
10 kHz +8 dB
100 Hz +6 48
10 kHz 26 dB
‘A020 V, 50 Hz (Europe, Asia, Australia & Hong Kong Models)
‘AC120\V, 60 Hz (U.S.A, Canada & Talwan R.0.C. Modets)
120W (US.A., Canada & Taiwan R.0.C, Models)
100 W (Europe, Asia & Hong Kong Models}
250 W (IEC) (Europe, Asia, Australia & Hong Kong Models)
4.0A(US.A,, Canada & Taiwan R.0.C, Models)
2W MAX (Standby)
434 (WN) x 144 (H) x 347 (D) mm (17-9192" x 5.49064" x 19-21/92")
9.9 kg (21 Ibs 18.02)
Infrared pulse system
8V DG, Two size REP ("AA") dry cell batteries
[54 (W) x 155 (H) x 29 (D) mm (2-1/8" x 6-7/64" x 1-164")
100 g (Approx. 3.5 02) (Including batteries)
* For improvement purposes, specifications and functions are subject to change without advanced notice.
2TER TS MA OSS
DISASSEMBLY
(Foltow the procedure below in reverse order when reassembling)
Top Cover
Remove 4 screws (on both sides, 3 screws () on the rear,
then detach the Top Cover.
Front Panel
Remove 6 screws @, 1 screw @ on upper and lower edges
‘of the Front Panel then detach itEE PMA-1055R
Inner Panel
1. Take off 6 knobs, 6 nuts, and 1 hold plate.
2. Remove 6 screws () fixing each P.W.B. Inner Panel (2
3. Remove 1 screws @)
4. Remove 2 screws
Hold Plate
Main P.W.B.
1. Remove 2 screws @) on the bottom,
2. Remove 1 screw @), 12 screws @ on the rear, then
dotach the Main P.W.B. and Heat sink in the arrow,
direction, Sink iBLOCK AND LEVEL DIAGRAM
< : a : ° a : w
&
eae f &
E os
| o
| &
(meg o
a :
es nese
o
®
aE we
o 4 wae
° a
ot wa
af
of 1
ol tesecnnoe
‘a
|| 23a
a
ee =
sno aus uy
noi or tT coum in0oae
ova @ S21 J] =hH~
OFF (ML)
VOLUME control > fully counterclockwise (C) min.)
SPEAKER terminals + open: do not connect the speakers, dummy load ot
© Adjustment
4, Remove top cover. And then connect DG voltmeter to the test points TP501 and TPS02 of MAIN AMP P.W.B.
2, Connect power cord to AC230V (218 - 242V) (Europe, Asia, Australia & Hong Kong Models) or AC120V (114 - 126V)
(U.S.A, Canada & TAIWAN P.0.C. Models) wall outlet, and turn POWER switch "ON" (mm)
3, Right after power on, adjust VA5O1 and VR502 so that the DC voltmeter reads 10+1mV.
4. Then after 2 minutes warmup, adjust VRSO1 and VRSO2 so that the DG voltmeter reads 10 mV.
5. And after 10 minutes warmup, adjust A501 and VR502 so that the DC voltmeter reads 10 40.5mV.SEMICONDUCTORS
@IC's
‘TMP87C846N (IC901)
‘TMP87C846N Terminal Function
Pin
No.
corn of
mre [|
sors Co
Jam
are |
wooirmire CE]
corn CH
waters CF
~
ol
0 Oo
ro Ol
Ol
ve Gel
ro Ox
=O
a
m
vor fa]
cessive Ga]
[I
fx) recur
fs re
FE) rut
[50 ries
[3 reer
[25 ror
[a0 mwas
[5a moa
[5 ssa
fa mie,
ae
fs mms
fed rao
fs mio
fara
[= over
wma S
ra we PRS,
saunteews
maaetey ec rane) mo
\oFe yess
Ph
Peet
vo;
Type:
Port Name
a
AG poner relay ave
Analog sich data
‘Analog witch strobe
Analog swrich clock
Mutefstandby LED drive
Motor volume
Remote contol signal input
‘TAPE:2 LED dtve
CTAPE-1LED dtve
TAT)
(NTS
AUX LED ave
‘TUNER LED arive
COLED dive
PHONO LED anv
Tovves
Reset
Xtal inp
Xtal oulpul
‘GND.
ToVoe
}o|o|o}o] o}o}olo|—ololo}olofolo
lololalolololajalaloaolololo
REC OUT selector sich pul
Function Swich encoder input
Ting signal oui
IND)
(iNT)
(NT2)
Brotedtor input
Power of
Motor velams down
‘STOP MODE cancal
'z|2|2|0|0|0/oloafofolo]ololololalolo
Terminal number of w com
‘The name entered in the data shea of year
Input or output of port
"= Input pot
tpt port
Composition of port incase of output port,
Function: Function and logical level ofthe signals tobe interfaced
PMA-1056R mmcat PMA-1055R
TCo163AN (IC202)
TCO164AN (1C203)
a
LB1639 (IC902)
GP1U271X (Remote
Rs
2 oat
oars
box
NuM2068DDC (IC401)
NJM2043DD (IC301)
NJM7806FA(S) (IC903)
NUM7812FA(S) (1C101)
7PBe- toot
Inv.
He oup
JBs+ io
@ TRANSISTORS
RIN1205 (2.2k-47k)
2SB1274 (RIS)
28D1913 (R/S)
@
vot
28K184C (GRY(BL) — MP1715
MNI715
® DIODES (including LED)
PTHOMO4BC222TS2F333 (TH701)
Ue comey Si
Soe sles) Eten
ty Sea) ao
DTATI4EK DTAII4EK DICI4EK
DTCI4EK 2 -
Etna —
3 eteanen Taek | ia | ioe
: ce]
4 shel
MTZU2.70 SLR-342VR (LED)
MTZJ3.3A SEL-12108
MTZJ6.2A
MTZu7.5C “. knob (P} Assy | lack mode
| 1199219000]. knob Assy Gold model
1
4
1
1
1
3
1
y
1
1
2
4
2
2
19 [273.460 009 |Tansiser 28ceses (avy |TASIS S16 2
1
1
1
1
2
4
‘
1
1
1
2
1
1
1
1
1
a
1
1
1
1
5 | 120120206 knob Assy) Back mal 1
16EXPLODED VIEW
a
A. rave cracal
Pars mar wth hie eyo
WARNING:mum PMA.“1055R,
WARING DIAGRAM
4 L 2 L 3
‘AC CORD,
1U-3248-6 AC UNIT
x70
SP TERNAL,
x70
2 TERIAL,
1U-3156-1 MAIN UNIT
oxtoe
SP Teeaana,
ces
Bona
B
cx
exon 8%
oan 7
7 u
fer
2P TESHINAL
if owos1 oxiee
4 wees ‘wo
1U-3248-7 Io CWwI61 16P-TKC-V
IP.SW. UNIT] 1U-3248-4 TONE UNIT
D f= OxTeT ToPTKOV
1U-3248-2
R. SEL. UNIT a
ere
eae 1U-3248-1 or
wearses uesise-4 ca F. SW. UNIT
| H/P UNIT 1u-g949-5
Feee gee MAIN VOL. UNIT fweaiverry
YO 1 1U-3248-3
ee See 1 SBte Gur
E
tu-g158-5
leo UNiT
x08
oF aR
18SCHEMATIC DIAGRAM
dl 1 2 L 3 L 4 1 5 1. ‘
4U-3 1566-4 MAIN UNIT
FE Sade SWOTPMA-1055R mom
A
B
c
ID
E
41U-3248—-3
U=CcOM UNIT
F
wh some ne |
Reh SIGNAL UNE
Nomice
[AL RESISTANCE VALUES IN OF K=1,000 OM M=1,000,000 oH Parts more with this symbol ital chractaration
—_] ‘AL CAEACITANGE VALUES WC AMGRO FARAD, PAMGRO-MicRD FaRAD Dee OAL rpcexment pas Tacmmandad Oy the
AGS VOLTAGE AND CURRENT ARE MEASURED AT NO SICNAL PUT CAUTION:
ESS returning r
GROUT ANO PARTS ARE SUBLECT To CHANGE WIHOUT PRR fag carer?
oe than 460 Koha the uit Ws detective
WARNING:
BONO yeiun the unit to the customer untt the problem Is ooates nd |B
SCHEMATIC DIAGRAM
4U-3156E MAIN P.W.B. UNIT
1U-3248E U-COM P.W.B, UNITPMA-1055R mam
PACKING VIEW
FRONT SiDE|
PARTS LIST OF PACKING & ACCESSORIES
Ref.No._| PartNo. | PartName Remarks [avy] [fot No. | Parin | Part Name Renate [on
201) 5606 9 Evape 1 ait | os 10S p
202 | 811 9667 005 nstrctin manual 1 211 | 5020896 038 | Spacer 2
axa) stsc7 1] 5 tay : aia si a7 2 |E2 Pos we inset |
mt Baroy Us 1 aie | si a7 0 £2 POs we ome | 4
203 | 8 708 Reet nee 9 1 aa] — [cancun 1
+ 205 | 510186108 ean set 1]] x 214] srosiroo1 fearon —fesemaiaany | 2
dor | 067 nao onsone + || es | sso 02| Conn oat) ‘
200 509296078 Cunon 2]] 4 216 | 51352001 | canon oa} 1
203 | sot 69 Cetoncse | li |
atNIPPON COLUMBIA CO. LTD.
“414, AKASAKA 4-CHOME, MINATO-KU, TOKYO 107-8011 JAPAN
“Telephone: 08 (9584) 8111
Prints in Japan x0081 1085 EI] 0008