LOAD CONTROL DATA LOGGING

HAND-HELD
QUICK-START GUIDE The hand-held will
automatically scan for
load banks in the
network on start up. TOP TIP
KEY: USB devices that contain upgrade
files can be connected to the hand-
held to update firmware both on the
LOAD SELECTION hand-held and all load banks in the
Select Load.
Press Manual Load network.
Decrease Load Entry to open the 10 digit
keypad for faster load
Increase Load selection.
Connect a USB flash drive
Manual Load Entry into the bottom of the
hand-held.
OK
Apply Load
TOP TIP
Reject Load TOP TIP The Increase and Decrease
Press OK to The total load available is Press Increase or Load buttons are the minimum
continue. displayed next to the 10 digit Decrease Load. load resolution of all of the load
NAVIGATION keypad. banks in the network.
Select load.
(Use steps listed in USB found symbol will
Next Screen Load Control). appear.
Down Screen
Back Screen
Network Overview
Network Search
Settings
Press Apply Load to Press Reject Load to
Status - Load Off start the load test. stop the load test.

Status - Load On
Press Reject Load to stop
Status - Warning data logging. Remove
Press Apply Load. Data the USB and insert into a
Status - Error capture will commence and computer to retrieve the
USB Found will blink. data log file.
Single Load Bank Control

OTHER SYMBOLS

Load Bank ID (Network view only)

USB Found Press Next Screen to view
line Voltages and Currents.
(Not available in single phase
mode).

WARNING! TOP TIP

The data log file created from
READ THE LOAD BANK MANUAL BEFORE USE AND TAKE
the hand-held can be opened
SPECIAL NOTE OF ALL SAFETY WARNINGS.
in spreadsheet software for
further analysis.
KEEP PEOPLE WELL AWAY. CLOSE ALL DOORS. ENSURE
CABLES AND EARTHING ARE ADEQUATE. ENSURE A 4M
GAP IS BETWEEN LOAD BANKS TO PREVENT HOT AIR
RECIRCULATION. RISKS INCLUDE FIRE AND BURNS FROM
THE HOT AIR OUTLET AND ELECTRIC SHOCK.
LOAD BANKS IN A NETWORK STATUS SETTINGS

Press Network Overview to Press Status. See Key for

view all of the load banks in Press Settings.
colour codes.
the network.

TOP TIP
Press Network Search to Select the working volt-
rescan for load banks. age and the connection
mode from the menus.

TOP TIP
Changing the Voltage will
de-rate the load steps
Press a Single Load Press Next Screen to to ensure correct load is
Press Next Screen to TOP TIP
Bank Control. edit the language, time applied.
view the event log. Status and logs are available and date.
for both individual load banks
and the load bank network.

The Load Bank ID is shown

on the bottom bar.
Set the date and time of
all the load banks on the
network for logging and
data capture.

Press Down Screen to

move through load
banks in the network. Up to 250 events are logged. After 250 events
occur the data is overwritten.

TOP TIP
The remote LED on the se-
lected load bank will blink.

ERRORS

A message will appear if an error occurs. Press

the screen to acknowledge. The load bank with
the error will be removed from the network until
it is cleared. For more information about errors
view the load bank manual. The ASCO and ASCO Power Technologies marks are owned by
Emerson Electric Co. or its affiliates and utilized herein under license.
Repeat the Load Control steps to apply and
©2017 ASCO Power Technologies. All Rights Reserved.
reject load and view instrumentation for any Publication No. 5052
load bank in the network.
Froment is a brand of ASCO Power Technologies.
Cliffe Road, Easton-on-the-Hill, Stamford, PE9 3NP, UK
www.froment.co.uk | [email protected] | +44 (0) 1780 480033