Specification :

Nominal pressure (MPa) 1.0

Shell 1.5
Testing pressure (MPa)
Seal 1.1
Working pressure (MPa) 1.0
Suitable temperature (°c) 80
Suitable medium Water

Technical Requirement
1. Design standard: BS EN 593:2004.
2. Flanges drilling : ASME B16.47 class150.
3. Face to face standard: BS EN 558:2008 Series 14.
4. Tests standard: BS EN 12266-1:2003 Rate A .
5. Internal bolts in st.st. AISI 304
6. Inside and outside epoxy coat 300 micron min
7. Valves are bidirectional
8. Flange between body and gearbox to ISO 5211

16 O-ring EPDM
15 Gearbox Ductile iron
T 14 Main shaft Stainless Steel SS304
13 Stuffing box Bronze
12 Stuffing EPDM
11 Body seal ring Stainless Steel SS304
10 Disk seal ring EPDM
9 Retaining ring Stainless Steel SS304
8 Disk Ductile Iron 65-45-12
7 Pin Stainless Steel SS304
6 Stub shaft Stainless Steel SS304
5 Body Ductile Iron 65-45-12
4 Bushes Stainless Steel + PTFE
3 O-ring EPDM
2 End plate Ductile Iron 65-45-12
1 Bolts Steel
No. Part Name Material
1500 1.0 750 Ø1855 Ø1759 Ø1676 62.5 2 52-Ø47.6 935 Ø640 1035 1326 30 158 600 2400:1 Fig.5
DN PN Torque In Rounds Ratio Mounting
(mm) (Mpa) L D D1 D2 b f n-d L1 D0 H1 H2 T (Nm) (Gearbox) Gear Flange
ORDER N° TYPE OF DRAWING QUANTITY TOT. KG DESIGNED BY CHECKED BY APPROVED BY TOLLERANCE NOT SHOW SCALE
DI NICOLA DATE
ACCORDING TO

TAB. N° SIGNAT.

D REPLACE
N.B.This drawing is given to you
TITLE
Double eccentric butterfly valve with REV.

INDICATIVE DRAWING
under strictly conditions that it
N REPLACED
must not be reproduced or given
to third person without our
gearbox and flange to electric actuator

BY autorization CODE

SAN GIOVANNI TEATINO-ITALY DN1500 PN10 flanged to ANSI 150