SOLAR CHARGE CONTROLLERS

Steca Solsum
0606, 0808, 1010
The Steca Solsum continues the huge success of one of the most
used SHS controllers. With a power range of up to 10 A at
automatically recognized 12 V or 24 V it fits to a system sizes of
maximum 240 W.
___Full circuit board protection with LED display for simple
recognition of battery status. Various connections make it possible
to connect easily to solar panels, battery and load. The Steca Solsum
F works on PWM as a low loss series controller.

Product features
Serial topology with MOSFETs
Automatic detection of voltage
Voltage regulation
PWM control
Multistage charging technology
Current compensated load disconnection
Automatic load reconnection
Temperature compensation
Negative earthing of one or positive earthing of several terminals
possible
Monthly equalisation charge

Electronic protection functions

Overcharge protection
Deep discharge protection
Reverse polarity protection of module (≤36 V),load and battery
Automatic electronic fuse
Short circuit protection of load and module
Overvoltage protection at module input
Open circuit protection without battery
Reverse current protection at night
Overtemperature and overload protection
0606 0808 1010
Load disconnection on battery overvoltage
Characterisation of the operating performance
System voltage 12 V (24 V)
Displays Own consumption < 4 mA
Multifunction LED display DC input side
Multi-coloured LED Open circuit voltage solar module (at < 47 V
4 LEDs show operating states minimum operating temperature)
for operation, state of charge, fault messages Module current 6A 8A 10 A
DC output side
Load current 6A 8A 10 A
Options
Reconnection voltage (LVR) 12.4 V … 12.7 V (24.8 V … 25.4 V)
Evening or night light function pre-set in the factory or
Deep discharge protection (LVD) 11.2 V … 11.6 V (22.4 V … 23.2 V)
adjustable via Steca PA RC 100 Battery side
Parameterisation of function values via Steca PA RC 100 End-of-charge voltage 13.9 V (27.8 V)
Boost charge voltage 14.4 V (28.8 V)
Certificates Set battery type gel
Compliant with European Standards (CE) Operating conditions
RoHS compliant Ambient temperature -25 °C … +50 °C
Made in EU Fitting and construction
Manufactured according to ISO 9001 and ISO 14001 Terminal (fine / single wire) 4 mm² / 6 mm² - AWG 12 / 9
Degree of protection IP 31
Dimensions (X x Y x Z) 145 x 100 x 30 mm
Accessories
Weight ca. 150 g
Steca PA RC100
Technical data at 25 °C / 77 °F
adjustable via Steca PA RC100: reconnection voltage, deep discharge protection, end of
charge voltage, boost charge voltage, battery type
Inverters must not be connected to the load output.

Version 2020-04-09 12:23 KATEK Memmingen GmbH | Mammostraße 1 | 87700 Memmingen | Germany | [email protected] | www.steca.de
Powered by TCPDF (www.tcpdf.org)