Saving time during unloading
Parallel and Series Connection of
Two Hydraulic Motors
Versions Your advantages
• Parallel and series circuit; reversing by using • Saves time during unloading thanks to the scraper
the tractor valve floor‘s slow-speed and fast-speed functions
• Parallel and series circuit with flow divider • Cost savings from the use of less expensive motors
in parallel operation; reversing by using
• Low installation costs
the tractor valve
• Few potential leakage points
• Parallel and series circuit; reversing capability
is built into the manifold block • Low pipework costs
• Compact construction means easy to incorporate into
the machine or to retrofit
Function
In parallel operation, the motors produce high
torque at half speed. Connected in series, the
situation is reversed, i.e. with the same oil supply,
the torque is halved, but the speed is doubled.
Depending on the version, the motors can be
reversed by means of the tractor valve, or the
reversing capability is already built into the
manifold block.
These parallel and series circuits are mainly used
to control the scraper floor drive on loader forage
wagons and dual-purpose wagons. The material that
was picked up (hay/grass, etc.), is usually discharged
slowly at the beginning. Towards the end of the
discharge operation, the system is switched over
to series connection, which enables the remaining
material to be discharged quickly. The reversing
capability is used to loosen any load that is
jammed in position.
Applications
• Scraper floor drives in loader forage wagons
• Scraper floor drives in dual-purpose wagons
Technical data / circuit diagrams
Variant 1: Variant 2: Variant 3:
Parallel and series circuit, reversing Parallel and series circuit with flow Parallel and series circuit,
capability is built into the manifold divider in parallel operation, reversing by using the
block reversing by using the tractor valve tractor valve
Qmax 100 l/min, pmax 210 bar Qmax 100 l/min, pmax 210 bar Qmax 100 l/min, pmax 210 bar
Reference: STB EGKG REV Reference: STB EGKG MT Reference: STB EGKG
M1 M1 M1 M1 M1 M1
A1 B1 B2 A2 A1 B1 B2 A2 A1 B1 B2 TL1 A2
A B A B A B
A B A1 B1 A2 B2 A3 B3
P LS T
pmax = 210 bar / Qmax = 120 l/min
or
or
CLOSED CENTER CLOSED CENTER OPEN CENTER
LOAD SENSING LOAD SENSING
www.bucherhydraulics.com © Bucher Hydraulics AG Frutigen 400-FL-000101-EN-00 / 09.2015
[email protected] Subject to change without notice
