Recommend!!

Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

Juniper
Exam Questions JN0-348
Enterprise Routing and Switching - Specialist (JNCIS-ENT)

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

NEW QUESTION 1
Click the Exhibit button.

A recent security audit indicates that peer-to-peer applications are allowed on the guest VLAN and employees may have been using the guest VLAN for this
purpose. You deploy the configuration shown in the exhibit, but it does not stop the peer-to-peer traffic.
In this scenario, what must you do to implement the security policy?

A. Implement 802.1X on the guest VLAN

B. Attach the filter to the VLAN
C. Deploy storm control to block unknown unicast traffic
D. Use persistent MAC learning

Answer: B

NEW QUESTION 2
Exhibit.

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

A number of reports from end users indicate that internal and external communications are intermittent and not reliable. You verified the status of the switch ports
and have determined that they are up and operational. You also noticed a very high level of link bandwidth utilization on those same ports. The current topology of
the affected environment is shown in the exhibit.
What would be the cause of the reported issues?

A. A lack of port-based ACLs filtering the traffic flows.

B. A malformed route-based ACL Improperly filtering traffic flows.
C. A misconfigured interior gateway protocol (IGP).
D. A lack of a loop-prevention mechanism or protocol.

Answer: D

NEW QUESTION 3
Click the Exhibit button.

Based on the output shown in the exhibit, which statement is correct?

A. This switch has been elected as the root bridge

B. This switch has a bridge priority of 32k
C. The ge-0/0/15 interface is using the default port cost
D. The ge-0/0/9 interface is using the default priority value

Answer: A

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

NEW QUESTION 4
Which two statements are true about high availability on Junos devices? (Choose two.)

A. BFD is faster at detecting failures than default GRE or OSPF timers.

B. NSR is independent of helper routers to assist the routing platform in restoring routing protocol information.
C. NSR is dependent on helper routers to assist the routing platform in restoring routing protocol information.
D. BFD is slower at detecting failures than default GRE or OSPF timers.

Answer: AB

NEW QUESTION 5
Which two situations would cause dynamic ARP inspection to drop traffic? (Choose two.)

A. If no IP-to-MAC address entry exists in the DHCP snooping database

B. If the IP address in the ARP packet is deemed invalid
C. If the requested MAC address exceeds the configured limit on the port
D. If the ARP packet comes from a port that has been configured as trusted

Answer: AC

NEW QUESTION 6
Which device is used to separate collision domains?

A. Switch
B. Router
C. Hub
D. firewall

Answer: A

NEW QUESTION 7
Which Junos feature allows you to combine multiple interface into a single bundle?

A. VRRP
B. Virtual Classis
C. LAG
D. NSB

Answer: C

NEW QUESTION 8
Your network connect to the Internet Through two different ISPs using EBGP. You must ensure that ISP1 is the primary path used for all traffic entering your
network while using ISP2 as a backup path.
In this scenario, which statement is correct?

A. You should use a lower MED value on routes sent to ISP1.

B. You should assign a higher local preference on routers that you are sending to ISP1.
C. You should change the next hop for all routes sent to ISP2.
D. You should your local AS number three times on routes that you are sending to ISP2.

Answer: D

NEW QUESTION 9
An EBGP session sources its TCP connection from which IP address?

A. The IP address of the primary address assigned to the loopback interface.

B. The IP address of the preferred address assigned to the loopback interface.
C. The IP address of the interface that connects the two BGP speakers.
D. The IP address assigned as the router ID.

Answer: C

NEW QUESTION 10
What are two interarea OSPF LSA types? (Choose two.)

A. Type 1 router LSAs

B. Type 2 network LSAs
C. Type 3 summary LSAs
D. Type 4 ASBR summary LSAs

Answer: CD

NEW QUESTION 10
Exhibit.

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

Referring to the exhibit, which policy will export routes to IBGP peers?

A. staric-4
B. scatic-2
C. static-1
D. static.c-2

Answer: A

NEW QUESTION 13
Exhibit.

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

Referring to the exhibit, which statement is correct?

A. The ge-0/0/15 interface is using the default port cost.

B. This switch has a bridge priority of 8k.
C. This switch is currently blocking all traffic.
D. The ge-0/0/9 interface is using the default interface priority value.

Answer: A

NEW QUESTION 15
You need to a new ESXi host connected to port ge-0/0/1. One of the VMs configured with VLAN 10 is not reachable from any other device on the switch. To
troubleshoot, you decide to verify of the VMs MAC address is learned properly under VLAN 10.
Which command would you use in this scenario?

A. Show Ethernet-switching table vlan-id 10

B. Show interfaces ge-0/01 detail
C. Show vlans 10
D. Monitor interface ge-0/01

Answer: A

NEW QUESTION 19
You have configured the route with an IS-IS metric of 2048. However, the IS-IS interface metric of 63 is being applied for the interface of this router.
What must you do to enable larger metric value?

A. Enable wide metrics.

B. Disable narrow metrics.
C. Restart the IS-IS protocol.
D. Enable level 1 IS-IS routing.

Answer: A

NEW QUESTION 24
Click the Exhibit button.

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

Referring to the exhibit, which router becomes the OSPF DR when all routers are powered on at the same time?

A. R3
B. R4
C. R1
D. R2

Answer: D

NEW QUESTION 27
Exhibit.

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

You have configured OSPF routing as shown in the exhibit. You notice that all interfaces have formed full adjacencies, with the exception of the interfaces
connecting R3 and R4 with a status of 2Way.
What is the reason for this status?

A. DROther routers will not form a full adjacency with each other.
B. The two routers must both be configured as DR routers.
C. The interface-type is not configured as p2p.
D. The two routers must be configured in different areas.

Answer: A

NEW QUESTION 28
Which statement is true about IP-IP tunnels?

A. Intermediate devices must have a route to the destination address of the traffic being tunneled.
B. Intermediate devices must have a route to both the tunnel source address and the tunnel destination address.
C. Intermediate devices must have a route to the tunnel destination address but do not require a route to the tunnel source address.
D. Intermediate devices must have a route to the tunnel source address but do not require a route to the tunnel destination address

Answer: B

NEW QUESTION 33
When configuring firewall filters, which function does the interface-specific parameter enable on an EX Series switch?

A. The interface-specific parameter is required to configure port-specific counters.

B. The interface-specific parameter is required to configure VLAN-specific counters.
C. The interface-specific parameter is required to configured VLAN-based filters.
D. The interface-specific parameter is required to configured port-based firewall filters.

Answer: A

NEW QUESTION 36
What is the default BGP group type on a Junos device?

A. Internal
B. External
C. Multihop
D. null

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

Answer: B

NEW QUESTION 38
Which three mechanisms are associated with the bridging process? (Choose three.)

A. blocking
B. flooding
C. aging
D. filtering
E. listening

Answer: BCD

NEW QUESTION 41
What are two methods for reducing the size of an OSPF link-state database? (Choose two.)

A. Use unique router IDs where possible.

B. Use identical link metrics where possible.
C. Use point-to-point interface types where possible
D. Use stub areas where possible.

Answer: CD

NEW QUESTION 43
What are two characteristics of OSPF ABRs? (Choose two.)

A. ABRs transmit routing information between the backbone and other areas.
B. ABRs cannot be part of the backbone and another area at the same time.
C. ABRs inject information from outside the OSPF domain.
D. ABRs link two OSPF areas

Answer: AD

NEW QUESTION 47
Click the Exhibit button.

Your router is configured to peer with your ISP’s router using BGP. You can only control your BGP configuration.
Which address families are negotiated between the two BGP peers shown in the exhibit?

A. inet-unicast inet-vpn-unicast 12vpn-signaling

B. inet-unicast
C. inet-vpn-unicast
D. inet-unicast inet-vpn-unicast 12vpn

Answer: B

NEW QUESTION 50

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

......

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full JN0-348 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/JN0-348-exam-dumps.html (94 New Questions)

Thank You for Trying Our Product

We offer two products:

1st - We have Practice Tests Software with Actual Exam Questions

2nd - Questons and Answers in PDF Format

JN0-348 Practice Exam Features:

* JN0-348 Questions and Answers Updated Frequently

* JN0-348 Practice Questions Verified by Expert Senior Certified Staff

* JN0-348 Most Realistic Questions that Guarantee you a Pass on Your FirstTry

* JN0-348 Practice Test Questions in Multiple Choice Formats and Updatesfor 1 Year

100% Actual & Verified — Instant Download, Please Click

Order The JN0-348 Practice Test Here

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

Powered by TCPDF (www.tcpdf.org)