Install Hypertem
commands for ciso switch:
-------------------
How to reset a Cisco WS-C3750G-24PS-S switch back to factory default settings.
default password for switch is 'cisco'
to reset switch:
remove power cable and insert it back\
now do the below commands in switch mode:
> flash_init
> dir flash:/
> delete flash:config.txt
> delete flash:<remove all the files from flash_init exclude software file .mz
or .bin and .backupfiles>
>boot
VLAN Creation TechLAN:
---------------
> configure terminal
> vlan <vland id for techLAN> exmp: > vlan 270
> name <vlanname for Tech LAN> exmp:> name VLAN270
> end
> copy running-config startup-config
VLAN Creation for MUX:
---------------
> configure terminal
> vlan <vland id for MUX> exmp: > vlan 271
> name <vlanname for MUX LAN> exmp:> name VLAN271
> end
> copy running-config startup-config
VLAN Creation Management:
---------------
> configure terminal
> vlan <vland id for Management> exmp: > vlan 272
> name <vlanname for Management> exmp:> name VLAN272
> end
> copy running-config startup-config
VLAN Creation Management:
---------------
> configure terminal
> vlan <vland id for Management> exmp: > vlan 272
> name <vlanname for Management> exmp:> name VLAN272
> end
> copy running-config startup-config
vlan ip/switch ip assinment
-----------------------------------
> configure terminal
>interface vlan 270
>ip address 10.102.20.58 255.255.255.0
>end
Port enablement for VLAN /Interface
======================================
> configure terminal
> interface GigabitEthernet1/0/1
> switchport access vlan 270 (if it is a tech LAN swithc, we need to provide the
techlan)
> switchport mode access
> end> copy running-config startup-config
Enabling swithport for OA port/chassis connection port:
---------------------------------------------------------
> configure terminal
> interface GigabitEthernet1/0/4
> switchport access vlan <management VLAN ID>
> switchport mode access
> end> copy running-config startup-config
Telnet enable for switch:
line con 0
line aux 0
line vty 0 15
transport input telnet ssh
transport output telnet ssh
SSH Enable:
Router(config)#hostname <host name>
Router(config)#ip domain-name <Domain Name>
Router(config)#crypto key generate rsa
Router(config)#ip ssh pubkey-chain
Router(conf-ssh-pubkey)#username <user name>
Router(conf-ssh-pubkey-user)#key-string
Router(conf-ssh-pubkey-data)#key-hash ssh-rsa <key ID>
Router(conf-ssh-pubkey-data)#end
Run one of below if you are unable to access
****************************************
ip default-gateway 10.102.20.60
ip classless
ip route 0.0.0.0 0.0.0.0 10.102.20.57
ip route 0.0.0.0 0.0.0.0 10.102.20.60
ip http server
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 10.63.64.5
ip route 10.61.0.96 255.255.255.248 10.61.1.186
ip route 10.61.0.96 255.255.255.248 10.61.1.190
