Scribd
Upload
52 views3 pages

Lab 1 Report ECE215L

Dr. Smith, This report summarizes the results of Lab 1 for ECE215L. In the lab, we used a function generator to create a sine wave signal and measured its frequency and amplitude using an oscilloscope. We also used resistors and capacitors in a voltage divider circuit to reduce the voltage of the signal and measured the output voltage. Finally, we calculated the theoretical values for the voltage divider circuit and compared them to our measured values to check the accuracy of our measurements and calculations. Overall, the lab helped me gain experience using oscilloscopes and function generators to analyze and characterize electronic signals.

Uploaded by

masood ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
52 views3 pages

Lab 1 Report ECE215L

Dr. Smith, This report summarizes the results of Lab 1 for ECE215L. In the lab, we used a function generator to create a sine wave signal and measured its frequency and amplitude using an oscilloscope. We also used resistors and capacitors in a voltage divider circuit to reduce the voltage of the signal and measured the output voltage. Finally, we calculated the theoretical values for the voltage divider circuit and compared them to our measured values to check the accuracy of our measurements and calculations. Overall, the lab helped me gain experience using oscilloscopes and function generators to analyze and characterize electronic signals.

Uploaded by

masood ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Lab 1 Report

Bader Alotaibi
ECE215L

You might also like