Scribd
Upload
246 views

Manual of vd100 Auto Scanner

1. Install the software from the website or CD-ROM, then install the scanner drive by downloading it from the website or CD-ROM, connecting the USB cable, and following the installation operations. 2. Find the scanner program icon in the desktop folder and run it to connect the equipment. 3. Set the correct COM port by checking Device Manager and selecting the same COM port in both Device Manager and the scanner program.

Uploaded by

Rodrigo Loss
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
246 views

Manual of vd100 Auto Scanner

1. Install the software from the website or CD-ROM, then install the scanner drive by downloading it from the website or CD-ROM, connecting the USB cable, and following the installation operations. 2. Find the scanner program icon in the desktop folder and run it to connect the equipment. 3. Set the correct COM port by checking Device Manager and selecting the same COM port in both Device Manager and the scanner program.

Uploaded by

Rodrigo Loss
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

VD100

1. First, install the software

Compressed packets can be downloaded from our website and also can be found
in our CD-ROM which will be enclosed in our product package.
Open the software then start to install, shown as follows

After finish to install the software, please in stall the drive.

2 Install the drive for the scanner


Drive can be downloaded from our website, and also can be found in CD-ROM.
Connect the USB cable one end to the multiplexer, and the other end to the
computer, and then install it according to the following operations

Find the following route,

CP210x\Win2K_XP\ PreInstaller
Click to install

After finish to do all the above steps, you will fin the icon as follows in the desk folder, please

double click it to run the program(Connected equipment，Connected to the

motorcycle ).

3 Com Port Setting


Right click my computer, then select properties.
Then click Hardware, and then click Device Manager

Then click Ports (COM PORT),and then select COM3


Run the program, also select COM3.

Notes: the COM port should be the same


DEMO：
Tips:
If you need to open full screen of the program,please change the resolution as 1024*768

You might also like