Room temperature
1. Press to switch on the device, wait until LCD shows zero. Press
to view temperature (in Celsius and Fahrenheit). Press again
to revert the normal weighing mode.
2. When converting to temperature display mode, LCD shows"----", meaning
the scale is testing temperature and will display temperature reading in
2 seconds.
Care and maintenance:
1.Wipe the scale with a slightly damp cloth. DO NOT immerse the scale in
water or use chemical/abrasive cleaning agents.
2.DO NOT stress the triangle ring for long time. During travel, keep the scale
away from objects with sharp ends (such as toy, stationery etc.), in case the
scale is switched on frequently and consume battery power.
3.To make sure accuracy, DO NOT use this scale in strong-magnetic field.
4.Keep the scale away from babies and children to avoid danger of swallow
the batteries and small components.
11EL-001E R1
Specifica tions
1. Room temperature display
Power
2. Zero and tare The scale is powered by 1x3V (CR2032) lithium battery. At the first time of use,
3. 0.44"(11.3mm) LCD digits open battery case cover on the right end of the scale. Remove battery isolation
4. Low battery / over load indication sheet before use.
5. Capacity: 50 kg /110 lb
6. Graduation: 50g / 0.1 lb
7. Power:1x3V lithium cell(CR2032)
To replace battery
LCD will display "Lo" when battery power is low. Replace battery as follows:
1. Hold the scale in one hand. The thumb and index finger of the other
hand hold and press on the screw threads of the battery case and pull
Key illustration
out the battery case from the slot.
Switch on/off (press for 2 seconds to switch off) 2. Push corner A outswards to release the used battery.
Convert between weight unit and temperature 3. To insert new battery, slide one side of new battery beneath the retainer
notch B & C. Press the other side of battery till it clips underneath the
corner A. Ensure to observe the polarity as illustrated in the drawing.
Weighing 4. Insert the battery case back to the slot on the scale.
1. Strap the webbing belt through the luggage handle, and secure the
hook of the belt onto the triangle ring. removable
battery case
2. Press to switch on the scale before lifting (ensure no stress) /slot
3. When display shows zero, press to select weight unit.
triangle ring
corner A
4. To re-weigh: press to reset LCD display to zero.
CR 20 32
5. Lift the scale gently. Make sure the scale is horizontal and balanced. 3V
LCD shows the weight of luggage. Wait for weight reading to stop and hook webbing belt
notch C
stabilise, flash 3 times and locked. Scale will display weight reading for notch B
2 minutes and automatically switch off. luggage handle Battery case
6. When weight reading is locked, press to reset LCD display to zero
and start new weighing. Scale will automatically switch off if idle for
1 minute.