Scribd
Upload
107 views3 pages

PowerTRONIC Map Switch Install Guide

This 3 sentence summary provides the essential details about installing a map switch for PowerTRONIC ECUs: The document provides instructions for installing a map switch that allows switching between two onboard maps without turning off the engine, including attaching the map selector to the handlebars, routing the switch wire under the seat, and connecting the switch connector to the PowerTRONIC wiring loom. Safety precautions and required tools are also listed.

Uploaded by

Gaurav
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
107 views3 pages

PowerTRONIC Map Switch Install Guide

This 3 sentence summary provides the essential details about installing a map switch for PowerTRONIC ECUs: The document provides instructions for installing a map switch that allows switching between two onboard maps without turning off the engine, including attaching the map selector to the handlebars, routing the switch wire under the seat, and connecting the switch connector to the PowerTRONIC wiring loom. Safety precautions and required tools are also listed.

Uploaded by

Gaurav
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

 

Map Switch Installation 


 
 
 
Document Version  1  Release Date  05 March 2019 
 
 
 
Application information  Generic 

Vehicle  Not Applicable 

Model  Not Applicable 

Year of manufacture  Not Applicable 

PowerTRONIC application  All PowerTRONIC ECUs, from firmware version F.3.x onward 
 
 
Note: 
 
● Read through all instructions before installation and use. 
● Ensure that the bike is switched off and the key is out of the ignition before proceeding with the 
installation. 
● Some parts of the bikes might be hot/sharp and may cause burns/cuts. Proceed with extreme 
caution or wait until the bike has cooled down. Always wear safety gloves.  
● When the installation is complete, make sure to secure the wiring loom away from the movable parts 
or components which tends to heat up during the normal operation of the vehicle at any chance.  
● PowerTRONIC is intended for motorsport use on a closed course, please check with your local laws 
before using this product. Race Dynamics / PowerTRONIC is not liable for consequences arising out 
of using the product. 

 
 
Support 
 
Call/Whatsapp: +91 99162 29292 / +91 80409 29292  
E-Mail: ​[email protected] 
Website: ​www.powertronicECU.com  
 

1
 
Tools Required 
● Allen key 
● Phillips head Screwdriver 
● Pliers 
● Cutters/Wire Strippers 

Map Switch Installation procedure 


Step 1: Attach the map selector to the handle bar using screws. (Refer figure below) 

 
 
 
 

2
Step 2: Detach the seat and route the map switch wire as shown in the figure. Roll any excess amount of wire 
under the seat (Refer figure below). 

 
 
Step 3: Locate the map switch connector male terminal on the PowerTRONIC wiring loom and connect the 
female terminal of the handlebar switch to this connector. Attach the seat back (Refer Figure below). 
 

 
Note: Maps can be changed on the fly. You do not have to turn the engine off to switch between the two on 
board maps. 
 
 
---/​End of Document​/--- 

You might also like