Page 1 of 3
204-02 Rear Suspension 2019 Ranger
Removal and Installation Procedure revision date: 12/5/2018
Rear Shock Absorber
Base Part Number: 18080
Special Tool(s) / General Equipment
Vehicle/Axle Stands
Removal
WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and
strut tube are gas pressurized and could explode if heated. Failure to follow this instruction may result in
serious personal injury.
WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can
extend unassisted. Failure to follow this instruction may result in serious personal injury.
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and
systems. Failure of these fasteners may result in major service expense. Use the same or equivalent
parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design.
Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
1. With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
2. Support the rear axle assembly.
Use the General Equipment: Vehicle/Axle Stands
http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/8/2019
Page 2 of 3
3.
1. Remove and discard the rear shock absorber upper and lower bolts and nuts.
Torque: 52 lb.ft (70 Nm)
2. Remove the rear shock absorber.
Installation
http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/8/2019
Page 3 of 3
1. To install, reverse the removal procedure.
Copyright © 2019 Ford Motor Company
http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/8/2019
