Page 1 of 3
303-14 Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS) 2019 Ranger
Removal and Installation Procedure revision date: 10/30/2018
Manifold Absolute Pressure and Temperature (MAPT) Sensor
Materials
Name Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound ESE-M1C171-A
XG-3-A
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. NOTICE: Do not pull the engine appearance cover forward or sideways to remove. Failure to press
straight upward on the underside of the cover at the attachment points may result in damage to
the cover or engine components.
1. Remove the engine appearance cover nut.
2. Place your hand under the engine appearance cover at each grommet location and pull straight up
to release each grommet from the studs.
3. After all of the grommets have been released from the studs, remove the appearance cover from
the engine.
2. Disconnect the electrical connector. Remove the retainer and the MAPT sensor.
Torque: 53 lb.in (6 Nm)
http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
Page 2 of 3
Installation
1. To install, reverse the removal procedure.
2.
1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine
appearance cover, and any future removal and installation of the cover.
Lubricate each grommet with silicone grease.
Material: Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-
M1C171-A)
2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
3. Press down on the engine appearance cover at each grommet location to attach the grommets onto
the studs.
4. Install the engine appearance cover nut.
Torque: 44 lb.in (5 Nm)
5. If the engine appearance cover stud bolt is loosened or removed, it must be installed/tightened into
the valve cover.
Torque: 62 lb.in (7 Nm)
http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
Page 3 of 3
Copyright © 2019 Ford Motor Company
http://www.fordservicecontent.com/Ford_Content/vdirsnet/workshop/ody/~WSKG/US/EN/... 1/9/2019
