Scribd
Upload
51 views

Lte Radio Protocol Architecture

Uploaded by

kapil singh
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
51 views

Lte Radio Protocol Architecture

Uploaded by

kapil singh
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

LTE RADIO PROTOCOL ARCHITECTURE

http://www.tutorialspoint.com/lte/lte_radio_protocol_architecture.htm Copyright © tutorialspoint.com

The radio protocol architecture for LTE can be separated into control plane architecture and user plane architecture as
shown below:

At user plane side, the application creates data packets that are processed by protocols such as TCP, UDP and IP, while
in the control plane, the radio resource control (RRC) protocol writes the signalling messages that are exchanged
between the base station and the mobile. In both cases, the information is processed by the packet data convergence
protocol (PDCP), the radio link control (RLC) protocol and the medium access control (MAC) protocol, before being
passed to the physical layer for transmission.

User Plane

The user plane protocol stack between the e-Node B and UE consists of the following sub-layers:

PDCP (Packet Data Convergence Protocol)

RLC (radio Link Control)

Medium Access Control (MAC).

On the user plane, packets in the core network (EPC) are encapsulated in a specific EPC protocol and tunneled between
the P-GW and the eNodeB. Different tunneling protocols are used depending on the interface. GPRS Tunneling
Protocol (GTP) is used on the S1 interface between the eNodeB and S-GW and on the S5/S8 interface between the S-
GW and P-GW.
Packets received by a layer are called Service Data Unit (SDU) while the packet output of a layer is referred to by
Protocol Data Unit (PDU) and IP packets at user plane flow from top to bottom layers.

Control Plane

The control plane includes additionally the Radio Resource Control layer (RRC) which is responsible for configuring the
lower layers.

The Control Plane handles radio-specific functionality which depends on the state of the user equipment which includes
two states: idle or connected.

Mode Description

Idle The user equipment camps on a cell after a cell selection or reselection process where factors like radio
link quality, cell status and radio access technology are considered. The UE also monitors a paging
channel to detect incoming calls and acquire system information. In this mode, control plane protocols
include cell selection and reselection procedures.

Connected The UE supplies the E-UTRAN with downlink channel quality and neighbor cell information to enable
the E-UTRAN to select the most suitable cell for the UE. In this case, control plane protocol includes
the Radio Link Control (RRC) protocol.

The protocol stack for the control plane between the UE and MME is shown below. The grey region of the stack
indicates the access stratum (AS) protocols. The lower layers perform the same functions as for the user plane with the
exception that there is no header compression function for the control plane.

You might also like