We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 1
XS Torque
9503, 9504
Mastertorque
9603, 9604
Ford Small Block
289, 302, 351W&C
(630) 849-7754 DF
!! WARNING !!
!! MEASURE RING GEAR DEPTH BEFORE INSTALLING STARTER !!
Pre-installation Checks
Before installing starter measure flywheel ring gear
depth. Measure from the engine side of ring gear to
the starter mounting surface. Refer to chart on right
of page for correct distance. Distance between Ring
starter Pinion Gear and flywheel Ring Gear must Go
be 1/16’, if less add Internal Shim (See Infi-clock
instruction sheet)
Rotate flywheel 360” and check for damaged ring
gear teeth. Worn or damaged teeth will cause
starter damage. Replace ring gear if needed
Wiring Instructions: Vehicles with remote Ford solenoid, use a jumper wire (12 Gauge) to
connect Battery and Ign terminal as shown in the illustration below. Then connect the starter
cable from the Ford solenoid to the Battery terminal on starter.
(Optional Wiring) Vehicles without. remote Ford solenoid, connect battery cable to Battery
Post on starter. Then connect a 12 gauge wire from the start switch to the Ign terminal on the
starter. (Do Not use Jumper Wire)
|< Starter Mounting Surface
1647 AIT, 1577 AT & VT
PIN's 9503, 9603
Depth Gauge
|
164 tooth WT
F-3] pin's 9504, 9604
|< — Starter Mounting Surface
> ‘With Remote Battery Condition:
Ford Solenoid Charge and Load Test Battery. A weak
or discharged battery can cause starter
Jumper failure.
Grounds:
Battery must be grounded to engine
block.
Cables and Wiring:
All terminals should be crimped and
2 i soldered. Connections clean and tight
Need Help? Call our Tech Line Do Not over tighten small ign
(630) 849-7754 Ee eee
void your warranty
Battery
Powermaster Performance 1833 Downs Dr West Chicago, IL 60185 (630) 957-4019 06 2010
