Scribd
Upload
173 views4 pages

Technical Report Templates

This technical report documents Muhammad Syafi Bin Noor Sazali measuring and determining the dimensions of various workshop tools and equipment over the course of five work processes. The tools measured include a vise using a steel ruler, a workbench using a measuring tape, a revolving tail stock using a vernier caliper, a hexagonal bolt using a micrometer, and taking readings from a dial gauge on a shaft. The total labor charges for the five measurement processes was RM 80.

Uploaded by

Aqil Hadif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
173 views4 pages

Technical Report Templates

This technical report documents Muhammad Syafi Bin Noor Sazali measuring and determining the dimensions of various workshop tools and equipment over the course of five work processes. The tools measured include a vise using a steel ruler, a workbench using a measuring tape, a revolving tail stock using a vernier caliper, a hexagonal bolt using a micrometer, and taking readings from a dial gauge on a shaft. The total labor charges for the five measurement processes was RM 80.

Uploaded by

Aqil Hadif
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Workshop Technology - 1

TECHNICAL REPORT
(FILL UP THE FORM BELOW)

NAME MUHAMMAD SYAFI BIN NOOR SAZALI


STUDENT ID 56103121092
WORK SHEET 1
MATERIAL COST DIMENSION:
(RM)

TECHNICAL DETAILS:

NO WORK PROCESS (IMAGE) WORKS DESCRIPTION TOOLS USAGE DURATION COSTING/BUDGET


1 Labours Charges:

MEASURING A VISE BY
USING A STEEL RULER STEEL RULER 10 MINUTES RM 10.00

2 Labours Charges:

Technical Report v1. 2022


1
Workshop Technology - 1

MEASURING A
WORKBENCH BY USING MEASURING TAPE 15MINUTES RM 15.00
A MEASURING TAPE

MEASURING A
REVOLVING TAIL STOCK
BY USING A VERNIER VERNIER CALIPER 15MINUTES RM 15.00
CALPER

Technical Report v1. 2022


2
Workshop Technology - 1

MEASURING A
HEXAGONAL BOLT BY MICROMETER 15MINUTES RM 15.00
USING A MICROMETER

TAKING READING OF
DIAL GAUGE FROM A DIAL GAUGE 25MINUTES RM 25.00
SHAFT

TOTAL LABOUR CHARGE RM 80.00

**Labours Charges: 10 Min /RM 10.00.


** Materials Charges: 5 mm / RM 20.00

Technical Report v1. 2022


3
Workshop Technology - 1

Prepared By

_______________________________

Technical Report v1. 2022


4

You might also like