HIGH STABILITY SMD TCXO
IT2100F
The IT2100F employs an analogue ASIC for the oscillator and a high order temperature compensation circuit in a 2.0 x 1.6 mm size package.
The device can be placed in power down mode through a single input pin. During standard operation, power consumption is minimised by
operating down to a supply voltage of 1.8V. The IT2100F's high stability, low power consumption, small footprint and powerful compensation
method makes it a TCXO ideally suited for demanding GNSS mobile applications.
Features Applications 2.0 x 1.6 mm
Excellent phase noise performance Time and frequency reference
Low start up drift rate o GNSS
Height less than 0.8 mm o Smartphone
Power down mode o Communications
Standard temperature stability of ±0.5 ppm o Consumer
over wide temperature ranges
Standard Specifications
Parameter Min. Typ. Max. Unit Test Condition / Description
Nominal frequency 13 - 52 MHz
Frequency calibration ±1 ppm Offset from nominal frequency measured at 25°C
±2°C
Reflow shift ±1 ppm Two consecutive reflows as per attached profile
after 2 hours relaxation at 25°C
Operating temperature range -40 85 °C The operating temperature range over which the
frequency stability is measured
Frequency stability ±0.5 – ppm Referenced to the midpoint between minimum and
over temperature ±2 maximum frequency value over the specified
temperature range 1.
Control voltage set to midpoint of VC
Frequency slope ±0.05 – ppm/°C Minimum of one frequency reading every 2°C over
±1 the operating temperature range 1
Static temperature hysteresis 0.6 ppm Frequency change after reciprocal temperature
ramped over the operating range. Frequency
measured before and after at 25°C
Sensitivity to supply voltage ±0.1 ppm VDD varied ±5% at 25°C
variations
Sensitivity to load variations ±0.2 ppm ±10% load change at 25°C
Long term stability ±1 ppm Frequency drift over 1 year at 25°C
Supply voltage (VDD) 1.8 – 3.3 V With a tolerance of ±5%
Supply current 2.2 mA At minimum VDD
Control voltage (VC) range 0.3 1.5 V The nominal Vc value is midway between the
VDD ≤ 2.3 V minimum and maximum. Voltage control should
not exceed the VDD +0.2 V or GND
Control voltage (VC) range 0.4 2.4 V The nominal VC value is midway between the
VDD > 2.3 V minimum and maximum. Voltage control should
not exceed the VDD +0.2 V or GND
Frequency tuning ±6 – ±30 ppm Frequency shift from minimum to maximum VC
Linearity 10 % Deviation from straight line curve fit
Control voltage input resistance 500 kΩ Measured between VC and GND pin
1Parts should be shielded from drafts causing unexpected thermal gradients. Temperature changes due to ambient air currents on the
oscillator can lead to short term frequency drift.
www.rakon.com [email protected] Page 1 of 2
HIGH STABILITY SMD TCXO
Model Outline and Recommended Pad Layout
Test Circuit
