Scribd
Upload
47 views1 page

Initial Configuration

The document provides instructions to log in to an A10 VM, configure passwords and interfaces, add a static route, and activate the appliance license by copying the host ID, getting a license key, and pasting it under licensing.

Uploaded by

Pradeep Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
47 views1 page

Initial Configuration

The document provides instructions to log in to an A10 VM, configure passwords and interfaces, add a static route, and activate the appliance license by copying the host ID, getting a license key, and pasting it under licensing.

Uploaded by

Pradeep Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Login into a10 VM username:admin password:a10

Type enable to enter into Privilege execution mode

Configure

Configure enable password


#enable-password Ab123456*

Configure management interface

#Interface management
#ip address 10.200.10.100 /24

Change administrator password


#admin admin password Ab123456*

#write mem

Open browser browse https://10.200.10.100

After login select network configure E1 interface with ip 192.168.10.100 netmask


255.255.255.0

Save

Network- routes add a static route dst is 0.0.0.0 subnet 0.0.0.0. gateway ip
192.168.10.254

Save

Go to system admin  select licensing  copy Host id


Login to glm.a10networks.com in to ur login
Click on licenses and select activate appliance- under appliance UUID paste HOST id select
4.1 and newer and click on activate appliance
You will receive an email with license key text . Copy key text and login into a10 paste it
uder systemadminlicensing  click on submit.

You might also like