Boscoseal PU
LIQUID POLYURETHANE WATERPROOFING MEMBRANE
DESCRIPTION
Boscoseal PU is a one-part ready to use coal tar free
bitumen modified, moisture curing polyurethane
membrane. After curing it provides a tough highly
elastomeric, impervious barrier to moisture. Suitable
for application by brush, roller or towel.
FEATURES AND BENEFITS
• Coal tar free
• One Part Polyurethane ready to use
• Brush, roller or trowel applied
• Does not brittle with age
• Exhibits tenacious adhesion to masonry
• Non re-emulsifying
required allow 24 hours between coats.
• Protection boards must be used to protect the
membrane before back filling or concreting.
RECOMMENDED USES • If Boscoseal PU is damaged, it can be repaired by
• Waterproofing of masonry walls, foundations cleaning the surface and recoating with Boscoseal
and basements PU.
• Waterproofing roof lap slabs, balconies,
courtyard Preparation
• Waterproofing under to terrazzo pawing and All surfaces must be clean, dry, free of voids, curing
quarry tiles compounds, loose materials, oil, grease, sealers and
• Waterproofing bathrooms, laundries and wet determined to be structurally sound before the
areas prior to tiling application of Boscoseal PU. New concrete must have
• Waterproofing planter boxes cured for 28 days.
APPLICATION PROCEDURE Priming
• Boscoseal PU can be applied by brush, roller, towel or Boscoseal PU does require priming on clean and dry
squeeze. substrates.
• Seal all cracks or joints up to 2mm in width with
Mixing
Bostik Seal N’ Flex 1 and Seal before application of the
Boscoseal PU does not require any mixing, simply use
membrane.
directly from container.
• Boscoseal PU can be applied immediately over Seal
N’ Flex 1 after initial set of approximately 6 hours at Precautions
25°C. Membrane should not be installed on wet,
• Boscoseal PU should be applied to achieve a dry contaminated, or friable substrate.
film thickness of 1.5mm minimum for optimum
performance. To achieve this dry film thickness apply • Rate of membrane cure will be inhibited when air or
Boscoseal PU at 1.1m•/litre/coat. substrate temperatures are below 75 °C.
• Extremely porous surfaces should be filled prior to • Should not be applied greater than 1.5mm in depth
coating and a second coat of Boscoseal PU should be in one application as the likelihood of foaming may
applied or use Boscoprime 1. occur.
• Apply Boscoseal PU evenly to avoid thin spots, air • Requires atmospheric moisture to fully cure. It should
entrapment or pin holes. Any defects can be repaired not be used on totally confined or air free spaces.
by over coating with Boscoseal PU. • Mortar bed screed or tiling should not be carried out
• For applications where two coats of Boscoseal PU are until membrane is fully cured.
• To eliminate possible surface contamination tiling
PERFORMANCE PROPERTIES
should be carried out as soon as possible after curing
or following trade protection may be required. Colour Black
• Bostik Boscoseal PU membrane should never be Appearance Smooth black paste, brushable, rollable
used as an exposed finish or as top coating exterior Shore “A”
membrane. Hardness 30
• Any intended application of Bostik Boscoseal PU Elongation at ~ 700%
membrane outside of recommended installation break
should be referred to Bostik R&D Technical Peel Strength 3-6kg/cm2
Department for approval. Moisture Vapour 1.412 g/hr/ft2
• Should not be applied over any form of lightweight Transmission
concrete.
Cure Time 24 hr
Product Flammability Non-flammable
One component bitumen modified polyurethane liquid
*Average laboratory values provided as a general guide
membrane for waterproofing. **Actual field performance will depend on installation and site conditions
Paintability Typical properties after 7 days cured at 25C and 50% RH
Boscoseal PU is not paintable.
Conforms to ASTM C836.76, ASTM D412, ASTM D2280
P.A.T.S (Pretested Adhesion To Substrate) Programme ASTME-96
Bostik offer a service in which a program has been
established to eliminate potential field problems Fire
by pre¬testing Bostik adhesives with samples of
building materials to which the adhesive will be applied. Boscoseal PU is non-flammable.
This service is available on large projects where BOSTIK BOSCOSEAL PU
pre-application testing will aid in determining the proper HANDI-CLEAN TOWELS
surface preparation method to achieve optimum
adhesion. Consult a Bostik representative for further
The representations and recommendations regarding the products are based
information.
on tests which we believe to be reliable. However, no guarantee of their
Health and Safety accuracy can be made because of the great range of field conditions and
On contact, uncured membrane causes irritation. variations encountered in raw materials, manufacturing equipment and
Gloves and protective goggles must be worn during methods. Thus, the products are sold with a limited warranty only, and on
application and use. the condition that purchasers will make their own tests to determine
the suitability of the product for their particular purposes. Under no
• Avoid contact with skin, eyes and avoid breathing in circumstances will Bostik Findley Australia Pty Ltd be liable to anyone except
vapour. for replacement of the products or refund of the purchase price.
• Wear protective gloves when mixing or using
• If poisoning occurs, contact a doctor or Poisons ALL SALES ARE EXPRESSLY LIMITED TO THE TERMS AND CONDITIONS OF SALE OF
Information Centre. BOSTIK FINDLEY AUSTRALIA PTY LTD
• If swallowed, do not induce vomiting. Give a glass of
water. FOR FURTHER INFORMATION
• If skin contact occurs, remove contaminated clothing BOSTIK FINDLEY BOSTIK FINDLEY BOSTIK FINDLEY BOSTIK FINDLEY AUSTRALIA
and wash skin thoroughly for a minimum of 15 PTY LTD NZ LIMITED SINGAPORE PTE LTD (MALAYSIA) SDN BHD Phone:
minutes and see a doctor. +61-3-9279 9333 Phone: +64-4-567 5119 Phone: +65-863 4088 Phone: +606 764
• For more detailed information refer to Material Safety 3246 Fax: +61-3-9279 9240 Fax: +64-4-567-5412 Fax: +65-863 4077 Fax:
Data Sheet. +606 764 3248
Clean - Up
SYDNEY ADELAIDE PERTH BRISBANE Phone: 02 8825 3488 Phone: 08 8244 0511
Bostik Boscoseal PU membrane can be cleared with
Phone: 08 9331 7666 Phone: 07 3265 2377 Fax: 02 8825 3411 Fax: 08 8244
Bostik 9907 or Mineral Turpentine before fully cured.
0522 Fax: 08 9331 7677 Fax: 07 3265 5421
Wear eye protection and use in well-ventilated area.
(ABN 79 003 893 838)
Do not use solvents on skin. Accidentally applied
Boscoseal PU on skin can be removed with Bostik DISCLAIMER:
Handi-clean towels. The information in this Technical Data Sheet is intended for the assistance
of users and is of a general nature. It reflects the extent of our knowledge
and experience of our products and is based on tests which we believe to be
Storage reliable. However, no guarantee of accuracy can be given due to the wide range
Store between 5°C and 30°C . When stored at or below of surfaces, environmental and field conditions and variations encountered in
raw materials, manufacturing equipment and methods at the place where the
30°C . Bostik Boscoseal PU has a shelf life of 12 months work is performed. Some of these will be beyond our knowledge and control.
from date of manufacture. All materials shall be stored Users are asked to make sure that the TDS in their possession is the latest issue.
Likewise, we recommend users carry out their own tests to determine the
under cover in a manner that will prevent damage suitability of the product for their particular purposes.
preferably on pallets and protected from excessive heat
Any claim for a defective product must be filed within 30 days of discovery of
and moisture. a problem and must be submitted with written proof of purchase. Claims are
not transferrable or assignable and extend only to the original purchaser/user.
Bostik reserves the right to inspect alleged failure and no responsibility will be
accepted unless Bostik is given the opportunity to do so. Bostik limits its liability
to the replacement of the product/s proven faulty.
BOSTIK HOTLINE
BOSTIK PHILIPPINES, INC.
35/F Penthouse Raffles Corporate Center
F. Ortigas Jr. Road, Ortigas Business Center Smart help +63 2 900 5656
Pasig City Philippines
Tel No: +63 2 900 5856 | Fax: +63 2 900 5616
