DS-K3B501SX
Swing Barrier
The DS-K3B501SX series swing barrier with 12 pairs of IR 12 pairs of IR light detectors: Permissions validation and
lights is designed to detect unauthorized entrance or exit. By anti-tailgating
adopting the swing barrier integratedly with the access LED light indicates passing direction
control system, person should authenticate to pass through Audible and visual nipping alarm: The barrier will stop
the lane via swiping IC or ID card, scanning QR code, etc. It is working for a period of time when detecting obstruction
widely used in attractions, stadiums, construction sites, when open/close barrier
residences, etc. Self-detection, Self-diagnostics, and automatic alarm
Valid passing duration settings: System will cancel the
passing permission if a person does not pass through the
lane within the valid passing duration
Door remaining open when fire alarm triggered: The
barrier will open automatically when alarm is triggered.
Barrier is in free status when powering down
Specification
System
MCBF ＞6 million times
Motor Servo motor
Interface
Network interface 1
RS-485 4
RS-232 4
Lock output 2
IO input 4
IO output 4
Capacity
Card capacity 60,000
Event capacity 180,000
General
20 to 60 persons per minute
Throughput The actual throughput is affected by the person passing rate and passing method.
Power supply method 100 to 240 VAC; 50 to 60 Hz
IR light detectors 12 pairs
Lane width 550 mm to 1100 mm (21.65" to 43.31")
Working temperature -25 °C to 65 °C (-13 °F to 149 °F)
Barrier material Stainless steel pipe; Acrylic glass
Working humidity 10% to 95% (No Condensing)
Pedestal material SUS304 stainless steel
Without packaging: 1500 mm × 200 mm × 960 mm (59.06" × 7.87" × 37.80")
Dimensions
With packaging: 1610 mm × 300 mm × 1100 mm (63.39" × 11.81" × 43.31")
Application environment Indoor and outdoor
Protective level IP54
Without packaging: 56 kg (left and right)/71 kg (middle) (123 lb/157 lb)
Weight With packaging: 86 kg (left and right)/100 kg (middle) (190 lb/221 lb)
Approval CE/FCC/CB/RoHS/REACH/WEEE
Maintenance
The main element of the turnstile is stainless steel, which is rustless (antioxidant) and corrosion resistant (The anti corrosion
ability in the medium of acid, alkali, and salt). In order to keep the stainless steel from being oxidized or corroded, you
should clean and care the turnstile surface periodically .
The instructions and tips for maintaining the turnstile are as follows:
Select different stainless steel types according to the variety of the environments. You can select 304 stainless steel for
common circumstances and 316 stainless steel for the scenarios of seasides and chemical plants.
Keep the device surface clean and dry.
Use non-woven cloth and ethyl alcohol to clean the dirt on the device surface.
Use sourcing pad (do not use mesh cleaning ball) to clean the rust on the device surface by following the wire drawing on
the stainless steel. And then use non-woven cloth and stainless steel cleaner to wipe the device surface.
Clean and maintain the device by using non-woven cloth and stainless steel cleaner periodically. It is suggest to clean the
device every month in common circumstances and every week for severe environments (seaside and chemical plants for
instance).
Available Model
DS-K3B501SX-L, DS-K3B501SX-M, DS-K3B501SX-R
Dimension
Accessory
Optional
DS-KAB-601COVER
DS-K3B601-BASE
Barrier's Face Recognization
Swing Barrier Base Module
Install Hole's Cover
