Scribd
Upload
50 views1 page

Teclado y Mouse Conecciones

This document provides installation instructions for a GE Healthcare Precision 500D R&F system. It describes mounting an optional modem enclosure and connecting the modem's power supply and control cable. Diagrams are included to illustrate the assembly.

Uploaded by

Francisco Diaz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views1 page

Teclado y Mouse Conecciones

This document provides installation instructions for a GE Healthcare Precision 500D R&F system. It describes mounting an optional modem enclosure and connecting the modem's power supply and control cable. Diagrams are included to illustrate the assembly.

Uploaded by

Francisco Diaz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

GE HEALTHCARE PRECISION 500D® R&F SYSTEM - INSTALLATION

REVISION 11 DIRECTION 2297166-100

Figure 8-10 IUI Accessory Enclosure

Figure 8-11 IUI Enclosure without Modem Installed

Holes within enclosure allow it to be mounted in different positions and surfaces.

1.7 Optional (Purchased) Modem


The modem is a option that must be purchased separately. If your system is delivered with a
modem installed, no action is required. If you have purchased the modem, perform the instructions
that follow:
1.) Connect the Precision 500D Modem Enclosure Power Harness to the modem's power supply.
2.) Place the power supply in the enclosure as shown in Figure 8-12.
3.) Place the locking bracket over the power supply and secure it with the two nuts.
4.) Tighten the locking bracket until the power supply is snug against the enclosure where it does
not move.
5.) Place the modem inside the enclosure and face it toward its power supply. See Figure 8-12.
6.) Place the locking bracket over the modem and secure it with the two nuts.
7.) Tighten the locking bracket until the modem is snug against the enclosure where it does not
move.
8.) Connect the modems power supply to the modem. See Figure 8-12.
9.) Connect the modem control cable to the modem. See Figure 8-12.

Figure 8-12 IUI Accessory Assembly with modem installed

Chapter 8 Console Page 219

You might also like