EC Type-Examination Certificate

Reg.-No.: 01/205/5297.03/22

Product tested Safety relay module for Certificate WEG DRIVES &
emergency stop applications holder CONTROLS -
AUTOMAÇÃO LTDA
AV. Pref. Waldemar
Grubba, 3000
89256-900 Jaraguá do
Sul / SC
Brazil

Type designation CP-D

Codes and standards EN ISO 13849-1:2015 EN IEC 62061:2021

EN 61508 Parts 1-7:2010 EN 60204-1:2018

Intended application Emergency stop applications, guard door monitoring (Stop Cat. 0). The
safety relay module complies with the requirements of the relevant
standards (Cat. 4 / PL e acc. to EN ISO 13849-1, SILCL 3 / SIL 3 acc. to
EN IEC 62061 / IEC 61508) and can be used in applications up to Cat. 4 /
PL e acc. to EN ISO 13849-1 and SIL 3 acc. to EN IEC 62061 / IEC 61508.
10/222 12. 12 E A4 ® TÜV, TUEV and TUV are registered trademarks. Utilisation and application requires prior approval.

Specific requirements The instructions of the associated Installation and Operating Manual shall

Tel.: +49 221 806-2434, Fax: +49 221 806-1354, E-Mail: [email protected]
be considered.

It is confirmed, that the product under test complies with the requirements for machines defined in Annex I TÜV Rheinland Industrie Service GmbH, Am Grauen Stein, 51105 Köln / Germany

of the EC Directive 2006/42/EC.

Valid until 2027-09-12

The issue of this certificate is based upon an examination, whose results are documented in
Report No. 968/M 385.04/22 dated 2022-09-12.
This certificate is valid only for products which are identical with the product tested.

Köln, 2022-09-12
Notified Body for Machinery, NB 0035 Dipl.-Ing. Jelena Stenzel

www.fs-products.com

Powered by TCPDF (www.tcpdf.org)