BLU Zoey 2.

4
Service Manual

Downloaded from www.Manualslib.com manuals search engine

 1. Main Functions:
-cool surface and Fashionable design
-Full keyboard for message writing
-Audio Play/Video recording /VGA Camera
-CMOS Camera, 0.08 M Pixel
-MMS/WAP/Email
-Support 4G T-Flash Card
-Support PC sync
-Track ball function
-Network GSM900/1800/850/1900

2. Main Selling Points

-FM radio/record
-12.4 QQVGA 240*320

3. Other Functions
-USB1.1
-SIZE 120.8*50.2*13.7mm

TABLE OF CONTENTS

INTRODUCTION………………………………………………………………………………...3
Chapter 1 EXPLODED VIEW AND COMPONENT DISPOSAL………………………..….4

Downloaded from www.Manualslib.com manuals search engine

 EXPLODED DIAGRAM…………………………………………………………………….….4

DISASSEMBLY AND ASSEMBLY …………………………………………………………….…….…5

SERVICE TOOLS………………………………………………………………………………...5

DISASSEMBLE…………………………………………………………………………….……...7

ASSEMBLY………………………………………………………………………………….……..8

Chapter 2 SYSTEM BLOCK DIAGRAM………………………………………………….....11

Chapter 3 INSTRUCTION OF THE UNIT CIRCUIT………………………………….……..12
Chapter 4 ACTUALL BOARD………………………………………………………….…..….21
SIDE A…………….…………………………………………..………………………………….…….….21

SIDE B……………………….…………………………………………………………………….…...….22

Chapter 5 TROUBLESHOOTING……………………………………………………….….…23
Chapter 6 SOFTWARE INSTRUCTION OF SW UPDATE……………………………..…..29
Chapter 7 FUNCTION TEST……………………………………………………………..…….36
Chapter 8 PARAMETER SETTING INSTRUCTION…………………………………………37

INTRODUCTION

The purpose of this document is to help service workshop technicians to service products. This service
manual must be used only by authorized service suppliers. The content of it is confidential. Please note
that provides other guidance documents for service suppliers. Follow these regularly and comply with

Downloaded from www.Manualslib.com manuals search engine

 the given instructions. while every effort has been made to ensure the accuracy of this document, some
errors may exist. please keep in mind also that this documentation is continuously being updated and
modified, so always watch out for the newest version.

CAUTIONS

Please refer to the phone’s user’s guide for instructions relating to operation, care, and maintenance,
which include important safety information.
1 Servicing and alignment must be undertaken by qualified personnel only.
2 Ensure all work is carried out at an anti-static workstation and that an anti-static wrist strap is
worn.
3 Use only approved components as specified in the parts list.
4 Ensure all components, modules, screws, and insulators are correctly re-fitted after servicing and
alignment
5 Ensure all cables and wires are repositioned correctly electrostatic discharge can easily damage
the sensitive components of electronic products. Therefore, every service supplier must observe the
precautions which mentioned above.

GENERAL REPAIR INFORMATION

1 Make sure your testing equipment is functioning properly before beginning repair work.
2 Before starting repairs you must observe ESD precautions such as being in your ESD protected
area and connecting your wristband.
3 Use gloves to avoid corrosion and fingerprints.
4 Cover windows and displays with a protective film to avoid dust and scratches.
5 Use a lint-free cloth to clean the LCD.
6 When cleaning the pads use a soft cloth\ESD brush and isopropanol. Do not use a glass fiber
pencil: this scratches the surface and will corrosion.
7 Non-faulty mechanical parts(except shielding lids and bent parts or soldered components).May be
reused if they are not soldered.
8 When removing the shielding lids make sure to replace them with new ones, otherwise the
high-frequency leakage can affect the device.
9 Always use the original spare parts.
10 Check the soldering joints of the parts concerned with regard to the fault symptom. And resolder
them if necessary.
11 Remove excess soldering flux after repair.
12 Observe the torque requirements when assembling the unit.
13 Please aware that some malfunctions may be software related and solved by an update

Chapter 1

EXPLODED VIEW AND COMPONENT DISPOSAL EXPLODED

Downloaded from www.Manualslib.com manuals search engine

 SERVICE TOOLS

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine
 Solder wire, soldering paste Wrist grounding strap, Antistatic gloves

Metal tweezers, Screw driver, SRT-6 Plates

Downloaded from www.Manualslib.com manuals search engine

 Chapter 2

SYSTEM BLOCK DIAGRAM

Downloaded from www.Manualslib.com manuals search engine

 Chapter 3

INSTRUCTION OF THE UNIT CIRCUIT

Circuit instruction of CPU

Downloaded from www.Manualslib.com manuals search engine

 CPU—input of the keypad

The joint circuit of the f master and the FLASH data

Downloaded from www.Manualslib.com manuals search engine

 Bluetooth control and data transmit port of master

Downloaded from www.Manualslib.com manuals search engine

 Data control port of Double SIM card

SIM 1 Data
interface

SIM 2 Data
interface

7.2 MT6260 CPU power supply port

Downloaded from www.Manualslib.com manuals search engine

 CPU voltage and current reference

Battery connector

Downloaded from www.Manualslib.com manuals search engine

 Audio frequency PA

To LoudSpeaker

I/O connector (5PIN)

Downloaded from www.Manualslib.com manuals search engine

 RF IC Build in MT6260

Power Supply

Logic Ctrl

TX Signal To RF PA

Crystal 26MHz RX from RF LNA

Downloaded from www.Manualslib.com manuals search engine

 RF PA IC

Downloaded from www.Manualslib.com manuals search engine

 FM radio

Downloaded from www.Manualslib.com manuals search engine

 SIM card circuit

Downloaded from www.Manualslib.com manuals search engine

 Chapter 4 PCB Layout chart

PCB layout SIDE A PCB layout SIDE B

Downloaded from www.Manualslib.com manuals search engine

 Loud Speaker

Micro USB

CPU(MT6260)

T-Flash
RF PA
Card

SIM2
SIM1

Charge
Circuit

Downloaded from www.Manualslib.com manuals search engine

 Chapter 5

TROUBLE SHOOTING Test flow chart of test SIM card

Downloaded from www.Manualslib.com manuals search engine

 Test flowchart of cannot power on (main)

Downloaded from www.Manualslib.com manuals search engine

 The test flowchart of head phone

Downloaded from www.Manualslib.com manuals search engine

 Test flowchart of incoming call with no ring.

Downloaded from www.Manualslib.com manuals search engine

 Test flowchart of no display or display abnormally.

Downloaded from www.Manualslib.com manuals search engine

 The test flowchart of download failed

Downloaded from www.Manualslib.com manuals search engine

 Chapter 6

Instruction of SW update

1 1. Install the USB driver without the USB cable plugged into the computer.
2 After it is ok, plug the cable then check the device manager as the picture below:

Downloaded from www.Manualslib.com manuals search engine

 3.Double click to run FlashTool_v3.0848

Choose right com port

1 You better choose auto format FAT in “Format FAT” like belows,
2 Tip Download Agent， choose MTK-ALLInOne.bin

Downloaded from www.Manualslib.com manuals search engine

 Choose “Auto Format FAT”,

Downloaded from www.Manualslib.com manuals search engine

 6. Tip Scatter-loading to choose “ txt ” file in the SW folder, such as scat25_08A_GEMINI. Then the
BOOTLOADER and ROM will also set to be well .

Downloaded from www.Manualslib.com manuals search engine

 7.Keep phone off , and tip Download to run the program, and the red bar appear, it shows the phone can connect
with this tool successfully, then it will write data into phone and tool will show the blue bar , after Ok appear with the
green circle. The process finish.

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine
 ¾ Check if the SW is correctly

8. Power on the phone and input“#*37#*”，check its version number on the first option.

Downloaded from www.Manualslib.com manuals search engine

 Chapter 7

FUNCTION TEST
Press “*#37*#” to check these items in stand by mode:

1 Version: to check the version of the software

2 Echo Loop: blow to the mic, the receiver will have a sound
3 Key: press relevant keys appear in the screen

1 Vibration: The cellphone will vibrate

2 Loud SPK: there will be a sound from the speaker
3 Ring: press start there will be some music from the speaker
4 LED: press confirm button to check if LED is normal
5 LCD: LCD will Auto Display

11. Receiver: there will be a sound from the receiver

Downloaded from www.Manualslib.com manuals search engine

 Chapter 8

PARAMETER SETTING INSTRUCTION China mobile as an example, other countries please

inquire the local operator
1. WAP parameter setting instruction
1) Data Account Process: Menu→Services→Data Account

GSM Data: Account Name: (default)

Number: 17266
User Name: WAP
Password: WAP
Line Type: ISDN
Speed: 9.6 Kbps
DNS: 010.000.000.172
GPRS: Account Name: (default)
APN: cnwap
User Name: WAP
Password: WAP

Auth. Type: (default)

2) WAP setting process: Menu→Services→WAP→Settings→Edit Profile

Edit Profile: Rename Profile: Optional Homepage: http://monternet.com
Data Account: GSM/GPRS Connection Type: HTTP (Proxy Address: 010.000.000.172)
Username: Optional Password: Optional
After setting as above, the WAP is ready.

2. MMS parameter setting instruction (Premise is WAP is valid)

Setting process: Menu→Messages→MMS→Message Settings→Server Profile→Edit profile
Edit Profile: Rename Profile: Same as WAP Profile name Homepage:
http://mmsc.monternet.com Data Account: Same as WAP Data Account
Connection Type: Same as WAP Data Account Username: Optional
Password: Optional
After setting as above, the MMS is ready.

3. Email parameter setting instruction (Premise is WAP is valid)

1) GPRS setting process: Menu→Services→Data Account→GPRS
Edit Profile: Account Name: Optional APN: cmnet 2) Email
Profile setting process: Menu→Messages→Email→Email Profile
A. Outgoing server: stmp.126.com (depend on the user’s Email website )
E-Mail Address: Full E-Mail Address of the user’s Password: Password of the use’s E-Mail
B. Incoming server: pop3.126.com (depend on the user’s Email website ) E-Mail Address: Full E-Mail
Address of the user’s Password: Password of the use’s E-Mail
After setting as above, the MMS is ready.

Downloaded from www.Manualslib.com manuals search engine