CUSTOMER:
PROJECT:
ZGOUNDER SILVER MINE EXPANSION PROJECT
TITLE: Merry-Crowe and Refinery . Data Sheet AFX040
095
PROJECT DOC NUMBER: ED: REV:
ZSM-DFM-4600-00000-ME-DS-1022 00 A
ISSUE PURPOSE: DATE:
For information
27/02/2023
PREPARED DATE:
BY:
27/02/2023
CB
CHECKED DATE:
BY:
27/02/2023
CB
APPROVED DATE:
BY:
27/02/2023
CB
PROJECT DOCUMENT NUMBER:
CHANGES CONTROL SHEET
ED REV DATE SECTIONS CHANGES DESCRIPTIONS
00 A 27/02/2023
This document contains proprietary
information of DF and is subject to the Page 1 of 3
restrictions set forth on the title page Date of Printing: 12/15/2022
Product Data Sheet
AFX040 Features
Pumps abrasive slurries, corrosive material, solids and gaseous liquids with ease
Ideal for high viscosity or shear sensitive products
Pumps can run-dry indefinitely without damage
No check valves or seal water flush systems
Fully reversible – pumps in either direction
Minimal maintenance – the hose is the only wearing part
Pump casings available in a choice of materials including stainless steel
Suction lift capability up to 9.5 metres and self-priming
Highly accurate
Technical Specifications
Maximum intermittent flow rate of: 8,736 litres per hour / 38.5 gallons per minute
Maximum continuous flow rate of: 6,552 litres per hour / 28.8 gallons per minute
Flow per revolution of: 1.82 litres / 0.48 gallons
Pressure capability of: 10 Bar / 150 psi
Maximum temperature: 80 Degrees Celsius / 176 Degrees Fahrenheit
Inner hose diameter of: 40 mm / 1½ inches
KEEPING FLUID IN MOTION
Technical Specifications
Operating Speeds: 0 to 80rpm
Product Temperature Range: -10 °C to +80 °C / 14 °F to 176 °F
Suction Lift: 9.5 metres / 30 feet lift
Hose Materials: Natural Rubber, Nitrile (Buna), EPDM and CSM
Connections available: DIN, ASA, JIS: mild steel galvanised
Hose Lubricant Required: 7.5 litres / 1.98 gallons
Sound level at 1m: < 70 dB(A) (pumping water at maximum continuous flow)
Optional Hose Failure Sensor: Capacitive DC sensor
Materials of Construction
Pump housing: Carbon steel or stainless steel
Rotor: Aluminium or carbon steel
Compression rollers: Aluminium or steel
Front cover: Carbon steel
Support Frame: Carbon steel
Seals: Neoprene or Nitrile
Approximate Weight 234kgs
Actual weight depends upon drive fitted.
Contact factory for details.
The information contained in this document is believed to be correct at the time of publication, but AFX Mixing and Pumping Technologies Inc. accepts no liability for any error it contains, and reserves
the right to alter specifications without prior notice. All values given in this document are values under controlled test conditions Actual site flow rates achieved may differ due to changes in tempera-
ture, product viscosity, suction and discharge pressures and/or system configuration.
Tel: +1 604 380 4458 13782, 232a Street
MIXING AND PUMPING Email:
[email protected] Maple Ridge
TECHNOLOGIES INC. Web: www.afxmixing.com BC, Canada V4R 0C2
