0% found this document useful (0 votes)
194 views2 pages

Evaluation Test Authorized Gas Tester

This document appears to be a test for participants who completed an Authorized Gas Tester (Advanced) course. It consists of 10 multiple choice questions testing knowledge of gases, gas monitoring, and confined space entry procedures. The test instructions state that candidates must correctly answer 80% of the questions to pass, and the course trainers have discretion to determine how failures will be addressed or to raise the passing percentage.

Uploaded by

vigo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
194 views2 pages

Evaluation Test Authorized Gas Tester

This document appears to be a test for participants who completed an Authorized Gas Tester (Advanced) course. It consists of 10 multiple choice questions testing knowledge of gases, gas monitoring, and confined space entry procedures. The test instructions state that candidates must correctly answer 80% of the questions to pass, and the course trainers have discretion to determine how failures will be addressed or to raise the passing percentage.

Uploaded by

vigo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

LEARNING EVALUATION TEST

Authorized Gas Tester (Advanced)

Course held on _____/_____/_______ at ___JGC Training Centre___________________

Name ____________________________ Surname________________________________


(Name and surname of course participant in block capitals)

TEST INSTRUCTIONS
At the end of the test all correct answers will be provided, any doubts will be clarified and incorrect answers
will be marked.
Candidates must answer 80% of questions correctly. Course trainers may determine, in
accordance with internal JGC procedures, how candidates failing to meet this minimum
requirement will be asked to demonstrate their understanding of course content. Trainers may
also decide to raise the minimum percentage required to pass the course at their own discretion.

FINAL TEST
What is the approximate normal percentage of
1 gases in air?
1

A Oxygen 17%, Carbon Dioxide 4% Nitrogen 78% A


B Oxygen 20.9%, Carbon Dioxide 0%, Nitrogen 78% B
C Oxygen 78%, Carbon Dioxide 20.9%, Nitrogen 0% C
While testing for gas in a confined space it is
2 important to take measurements at different levels 2
because:

Gases always sink to the lowest level of a


A A
confined space

Some gases are heavier or lighter than air,


B B
causing stratification

C Gases always rise to the top of a confined space C


Which 4 sensors are usually standard in a
3 3
portable gas monitor?
A Chlorine, Freon, Argon, Acetylene A
B Nitrogen, Helium, Sulphur Dioxide, Propane B
C Oxygen, Methane, H2S, Carbon Monoxide C
The alarm for flammable gases is set at which
4 4
% of the LEL?
A 20% (Sometimes 10%) A
B 40% B
C 80% C
What are the key characteristics of Carbon
5 5
Monoxide?

A Odourless, colourless, found in exhaust fumes A

B Smells of rotten eggs, visible B


C Non-flammable found in refrigerators C

HMDSS – Learning Evaluation Rev0 22-02-2017 [Type text] Page 1


LEARNING EVALUATION TEST

6 The initial gas test should be conducted… 6

A Immediately before entry A


B Before the PTW is opened B
C During entry C

7 Continuous gas monitoring is; 7

Required where a hazardous atmosphere may


A A
occur
B During work inside the confined space B
C No required C

8 Who is authorised to act as an AGT? 8

A Trained, designated personnel A


B Anyone who knows how to use a gas monitor B
C The Safety Officer only C
When using mechanical ventilation what
9 precaution should be taken before 9
conducting a gas test?

A Read the monitor manual A


B Switch off the ventilation and wait a while B
C Ensure the ventilation is still operating C

How often should the gas tester be calibrated


10 10
by the manufacturer?

A Once every Month A


B Once every Year B
C Never C

Date ____/____/______ Signature ___________________________

PART TO BE FILLED IN BY THE TRAINER

Signature _______________________________
POINTS: __/10

HMDSS – Learning Evaluation Rev0 22-02-2017 [Type text] Page 2

You might also like