Scribd
Upload
70 views2 pages

Laboratorio 12 Configurando RIPv2

R1, R2, and R3 are configured with RIPv2 to share routing information. R1 is configured with a default route and RIPv2 on connected networks, excluding passive interfaces. R2 and R3 are similarly configured with RIPv2. Route tables are verified, showing all networks and the default route. Connectivity between all devices is confirmed.

Uploaded by

Ibeth Amalia Maquera
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
70 views2 pages

Laboratorio 12 Configurando RIPv2

R1, R2, and R3 are configured with RIPv2 to share routing information. R1 is configured with a default route and RIPv2 on connected networks, excluding passive interfaces. R2 and R3 are similarly configured with RIPv2. Route tables are verified, showing all networks and the default route. Connectivity between all devices is confirmed.

Uploaded by

Ibeth Amalia Maquera
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

TALLER DE REDES Y COMUNICACIÓN DE DATOS

Laboratorio Nº 12

Packet Tracer - Configurando RIPv2

Objectives
Part 1: Configure RIPv2
Part 2: Verify Configurations

Background
Although RIP is rarely used in modern networks, it is useful as a foundation for understanding basic network
routing. In this activity, you will configure a default route, RIP version 2, with appropriate network statements
and passive interfaces, and verify full connectivity.

Part 1:     Configure RIPv2


Step 1:     Configure RIPv2 on R1.
a.     Use the appropriate command to create a default route on R1 for all Internet traffic to exit the network
through S0/0/1.
b.    Enter RIP protocol configuration mode.
c.     Use version 2 of the RIP protocol and disable the summarization of networks.
d.    Configure RIP for the networks that connect to R1.
e.     Configure the LAN port that contains no routers so that it does not send out any routing information.
f.     Advertise the default route configured in step 1a with other RIP routers.
g.    Save the configuration.

Step 2:     Configure RIPv2 on R2.


a.     Enter RIP protocol configuration mode.
b.    Use version 2 of the RIP protocol and disable the summarization of networks.
c.     Configure RIP for the networks directly connected to R2.
d.    Configure the interface that contains no routers so that it does not send out routing information.
e.     Save the configuration.

Step 3:     Configure RIPv2 on R3


Repeat Step 2 on R3.

Part 2:     Verify Configurations


Step 1:     View routing tables of R1, R2, and R3.
a.     Use the appropriate command to show the routing table of R1. RIP (R) now appears with connected (C)
and local (L) routes in the routing table. All networks have an entry. You also see a default route listed.
b.    View the routing tables for R2 and R3. Notice that each router has a full listing of all the 192.168.x.0
networks and a default route.

Step 2:     Verify full connectivity to all destinations.


Every device should now be able to ping every other device inside the network. In addition, all devices should
be able to ping the Web Server.

You might also like