Scribd
Upload
267 views1 page

Vertical Multistage Wet Pit Pump Specs

This document describes a vertical multistage wet pit pump that can handle clear, corrosive, and flammable liquids. It lists the standard construction materials as cast iron, steel, and various stainless steels. It also provides performance specifications including a capacity up to 250 cubic meters per hour, a total head up to 250 meters, and an operating pressure up to 25 bars. The pump is suitable for industries like oil refining, petrochemical, chemical, and power stations.

Uploaded by

sita
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
267 views1 page

Vertical Multistage Wet Pit Pump Specs

This document describes a vertical multistage wet pit pump that can handle clear, corrosive, and flammable liquids. It lists the standard construction materials as cast iron, steel, and various stainless steels. It also provides performance specifications including a capacity up to 250 cubic meters per hour, a total head up to 250 meters, and an operating pressure up to 25 bars. The pump is suitable for industries like oil refining, petrochemical, chemical, and power stations.

Uploaded by

sita
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

VERTICAL MULTISTAGE WET PIT PUMP

VN For clear, corrosive, flammable, liquids

zConstruction: zStandard materials: zIndustries:


z Single or multistage z Cast iron (I1) z Oil refining
z Differentialhead as required z Steel casing - cast iron impellers z Petrochemical industry
z Side discharge through pump head (S1) z Chemical industry
z Thrust bearings oil or grease lubri- z Steel and chromium steel (S6) z Power stations
cated z 18/10/2.5 austenitic stainless steel z General industry
z Column shaft with product-lubricat- * (A8)
ed bearings z Other materials available upon
zPerformances:
z Concentric discharge avoiding radi- request.
al loads on bearings * The values shown are the percentages in
z Capacity : up to 250 m3/h or 1,100
z Excellent efficiency Cr/Ni/Mo
USGPM
z Shaft sealing by packing or stan-
z Total head : up to 250 m or 820 ft
dard single, double or tandem zOptional constructions: z Maximum operating pressure up to
mechanical seal
25 bar or 362 PSI
z Foundation ring available z Can pump for very low NPSHa z Temperature operating range : from
z Inducer available z Design for high temperature molten -40 to 120°C or -40 to 250°F.
z API 610 design (VS 1 or VS6) salts Special design cryogenic or very
available z Design with steam jacket high temperature
z Maximum speed : 3,000 rpm at 50
Hz

You might also like