Recommend!!

Get the Full 300-710 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/300-710-exam-dumps.html (182 New Questions)

Cisco
Exam Questions 300-710
Securing Networks with Cisco Firepower (SNCF)

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full 300-710 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/300-710-exam-dumps.html (182 New Questions)

NEW QUESTION 1
What are the minimum requirements to deploy a managed device inline?

A. inline interfaces, security zones, MTU, and mode

B. passive interface, MTU, and mode
C. inline interfaces, MTU, and mode
D. passive interface, security zone, MTU, and mode

Answer: C

NEW QUESTION 2
With Cisco Firepower Threat Defense software, which interface mode must be configured to passively receive traffic that passes through the appliance?

A. inline set
B. passive
C. routed
D. inline tap

Answer: B

NEW QUESTION 3
Which protocol establishes network redundancy in a switched Firepower device deployment?

A. STP
B. HSRP
C. GLBP
D. VRRP

Answer: A

NEW QUESTION 4
Which Cisco Firepower Threat Defense, which two interface settings are required when configuring a routed interface? (Choose two.)

A. Redundant Interface
B. EtherChannel
C. Speed
D. Media Type
E. Duplex

Answer: CE

NEW QUESTION 5
Which two actions can be used in an access control policy rule? (Choose two.)

A. Block with Reset

B. Monitor
C. Analyze
D. Discover
E. Block ALL

Answer: AB

NEW QUESTION 6
What is the result of specifying of QoS rule that has a rate limit that is greater than the maximum throughput of an interface?

A. The rate-limiting rule is disabled.

B. Matching traffic is not rate limited.
C. The system rate-limits all traffic.
D. The system repeatedly generates warnings.

Answer: B

NEW QUESTION 7
Which Firepower feature allows users to configure bridges in routed mode and enables devices to perform Layer 2 switching between interfaces?

A. FlexConfig
B. BDI
C. SGT
D. IRB

Answer: D

NEW QUESTION 8

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full 300-710 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/300-710-exam-dumps.html (182 New Questions)

Which two types of objects are reusable and supported by Cisco FMC? (Choose two.)

A. dynamic key mapping objects that help link HTTP and HTTPS GET requests to Layer 7 application protocols.
B. reputation-based objects that represent Security Intelligence feeds and lists, application filters based on category and reputation, and file lists
C. network-based objects that represent IP address and networks, port/protocols pairs, VLAN tags, security zones, and origin/destination country
D. network-based objects that represent FQDN mappings and networks, port/protocol pairs, VXLAN tags, security zones and origin/destination country
E. reputation-based objects, such as URL categories

Answer: BC

NEW QUESTION 9
Which report template field format is available in Cisco FMC?

A. box lever chart

B. arrow chart
C. bar chart
D. benchmark chart

Answer: C

NEW QUESTION 10
Which group within Cisco does the Threat Response team use for threat analysis and research?

A. Cisco Deep Analytics

B. OpenDNS Group
C. Cisco Network Response
D. Cisco Talos

Answer: D

NEW QUESTION 10
Which CLI command is used to generate firewall debug messages on a Cisco Firepower?

A. system support firewall-engine-debug

B. system support ssl-debug
C. system support platform
D. system support dump-table

Answer: A

NEW QUESTION 11
Which command is entered in the Cisco FMC CLI to generate a troubleshooting file?

A. show running-config
B. show tech-support chassis
C. system support diagnostic-cli
D. sudo sf_troubleshoot.pl

Answer: D

Explanation:
41 Which CLI command is used to control special handling of ClientHello messages?
A. system support ssl-client-hello-tuning
B. system support ssl-client-hello-display
C. system support ssl-client-hello-force-reset
D. system support ssl-client-hello-enabled

NEW QUESTION 12
When do you need the file-size command option during troubleshooting with packet capture?

A. when capture packets are less than 16 MB

B. when capture packets are restricted from the secondary memory
C. when capture packets exceed 10 GB
D. when capture packets exceed 32 MB

Answer: D

NEW QUESTION 14
Which limitation applies to Cisco Firepower Management Center dashboards in a multidomain environment?

A. Child domains can view but not edit dashboards that originate from an ancestor domain.
B. Child domains have access to only a limited set of widgets from ancestor domains.
C. Only the administrator of the top ancestor domain can view dashboards.
D. Child domains cannot view dashboards that originate from an ancestor domain.

Answer: D

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full 300-710 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/300-710-exam-dumps.html (182 New Questions)

NEW QUESTION 15
What is a behavior of a Cisco FMC database purge?

A. User login and history data are removed from the database if the User Activity check box is selected.
B. Data can be recovered from the device.
C. The appropriate process is restarted.
D. The specified data is removed from Cisco FMC and kept for two weeks.

Answer: C

NEW QUESTION 19
Which action should you take when Cisco Threat Response notifies you that AMP has identified a file as malware?

A. Add the malicious file to the block list.

B. Send a snapshot to Cisco for technical support.
C. Forward the result of the investigation to an external threat-analysis engine.
D. Wait for Cisco Threat Response to automatically block the malware.

Answer: A

NEW QUESTION 24
Which Cisco Advanced Malware Protection for Endpoints policy is used only for monitoring endpoint actively?

A. Windows domain controller

B. audit
C. triage
D. protection

Answer: B

NEW QUESTION 28
In a Cisco AMP for Networks deployment, which disposition is returned if the cloud cannot be reached?

A. unavailable
B. unknown
C. clean
D. disconnected

Answer: A

NEW QUESTION 29
Which two remediation options are available when Cisco FMC is integrated with Cisco ISE? (Choose two.)

A. dynamic null route configured

B. DHCP pool disablement
C. quarantine
D. port shutdown
E. host shutdown

Answer: CD

NEW QUESTION 30
......

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

 Recommend!! Get the Full 300-710 dumps in VCE and PDF From SurePassExam
https://www.surepassexam.com/300-710-exam-dumps.html (182 New Questions)

Thank You for Trying Our Product

We offer two products:

1st - We have Practice Tests Software with Actual Exam Questions

2nd - Questons and Answers in PDF Format

300-710 Practice Exam Features:

* 300-710 Questions and Answers Updated Frequently

* 300-710 Practice Questions Verified by Expert Senior Certified Staff

* 300-710 Most Realistic Questions that Guarantee you a Pass on Your FirstTry

* 300-710 Practice Test Questions in Multiple Choice Formats and Updatesfor 1 Year

100% Actual & Verified — Instant Download, Please Click

Order The 300-710 Practice Test Here

Passing Certification Exams Made Easy visit - https://www.surepassexam.com

Powered by TCPDF (www.tcpdf.org)