PLASTERING

Quality Control Checklist

Building : ________________________________________ Floor : ___________________________________________
Room : ________________________________________ Contractor : ___________________________________________

S#. DESCRIPTION Encircle REMARKS

A PRE-PLASTERING PREPARATION
1 Is Setting out done as per base reference line/drawing? Y N NA
2 Do Sufficient level pegs provided and wall alignment is acceptable? Y N NA
3 Do All first fixed joinery items are fixed accordingly? Y N NA
4 Do All concealed MEP services are complete and ready. (MEP Engineer Y N NA
confirmed to proceed)?
5 Is Protection/Safety provided to installed components/ finishes? Y N NA
6 Is Wire mesh provided between RC structure and brickwork? Y N NA
7 Is Mortar spread on the walls yet to be plastered is cleaned? Y N NA
8 Does Architectural items such as corner beads, U-grooves, copings and Y N NA
sides of jamb are completed prior to plastering work?
9 Do All finished works are well protected prior to plastering work? Y N NA
10 Check wall's moisture content, is it acceptable? Ensure wetting of substrate Y N NA
before plastering.
B CEMENT MORTAR MIXING & DURING PLASTERING
1 Is Corrected and clean sand material is used with plastering cement Y N NA
mortar mix ratio as per specification?
2 Does Adequate lighting provided at work area? Y N NA
3 Does Verticality and minimum thickness for plastering is maintained? Y N NA
4 Is cement slurry or lime finish is done after all minor unevenness is covered Y N NA
by rough finish in thin layers? (Where applicable)
5 Is Plastering is started from the top and gradually worked downwards to the Y N NA
floor?
6 Is the Mortar is consumed within the initial setting time for cement of Y N NA
not more than 30 minutes?
7 Do Plaster is roughened with stick broom/brush for area where second layer Y N NA
of plaster is specified
8 Does Edges/corners of all doors/windows opening are completed along with Y N NA
plastering?
9 Are the Grooves provided as per drawings otherwise at the junction of Y N NA
two different materials with prior approval from OIC? (If applicable)
10 For joint to be left out, it is straightly chopped with chamfered edges? Y N NA
11 Does the Curing started 12 hours after plastering? Y N NA
C FINAL PLASTERING FINISHES
1 Are there Visually acceptable smooth surface with no scratches? Y N NA
2 Check the evenness, line, plumb etc., using straight edge with Y N NA
respect to button marks. Are they Inline?
3 Do All button marks are carefully removed and properly finished after all Y N NA
checking?
4 Is there any surface damage or cracks and does surface is free Y N NA
from major defects?

Name of Site Supervisor (SS): Name of officer in-charge (OIC):

Checked & Signed: Reviewed Non-compliance: Verified & Signed: Reviewed Non-compliance:

Date: Date: Date: Date: