Scribd
Upload
126 views4 pages

USB Driver Setup for Liferaft Check

The document provides instructions for installing USB drivers on a laptop to use with Survitec Group liferaft inspection software. It involves inserting an installation CD, opening the CD folder, installing FTDI-chip drivers from the folder, which will automatically install the necessary USB drivers. Once installed, the annual liferaft inspection can be performed using the laptop and USB cable.

Uploaded by

jaja albino
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
126 views4 pages

USB Driver Setup for Liferaft Check

The document provides instructions for installing USB drivers on a laptop to use with Survitec Group liferaft inspection software. It involves inserting an installation CD, opening the CD folder, installing FTDI-chip drivers from the folder, which will automatically install the necessary USB drivers. Once installed, the annual liferaft inspection can be performed using the laptop and USB cable.

Uploaded by

jaja albino
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Survitec Group

RFD Beaufort Limited


Kingsway, Dunmurry, Belfast, BT17 9AF, Northern Ireland, United Kingdom
Tel: +44 (0)28 9030 1531 / Email: [email protected]
www.survitecgroup.com


USB Driver Installation Procedure
What to do if the green LED on the USB cable does not flash when using a laptop with the Survitec
Group Software, when performing the annual inspection of the Survitec ESR liferaft.

1. Insert the “ Survitec Group Extended Service Liferaft Installation Software & Instructions CD” into the laptop CD
tray.

2. When the “AutoPlay” dialogue box loads select “Open folder to view files.”


Survitec Group

RFD Beaufort Limited


Kingsway, Dunmurry, Belfast, BT17 9AF, Northern Ireland, United Kingdom
Tel: +44 (0)28 9030 1531 / Email: [email protected]
www.survitecgroup.com

3. The CD’s contents folder will open.

4. Insert the clear end of USB cable into one of the laptop’s USB ports.


Survitec Group

RFD Beaufort Limited


Kingsway, Dunmurry, Belfast, BT17 9AF, Northern Ireland, United Kingdom
Tel: +44 (0)28 9030 1531 / Email: [email protected]
www.survitecgroup.com

5. In the CD contents folder, select “FTDI-chip drivers” and start up the application.

6. When the application opens, the following dialogue box will appear and the driver installation will begin.


Survitec Group

RFD Beaufort Limited


Kingsway, Dunmurry, Belfast, BT17 9AF, Northern Ireland, United Kingdom
Tel: +44 (0)28 9030 1531 / Email: [email protected]
www.survitecgroup.com

7. Once Windows has finished installing the drivers, the message below will be displayed and the dialogue box will
automatically close.

8. Remove the CD from the tray.

9. Proceed with the annual on-board inspection.



You might also like