GS33910060800
Dupline® Profinet Gateway
Benefits
• Profinet gateway with the function as a slave
• Up to 7 master generators can be connected via the HS
RS485 bus (side connector)
• All Dupline® signals from the master generators are
available on Profinet
• Mini webserver for diagnostics of Profinet and Dupline®
networks
• Integrated 2-port switch
• 2-DIN UWP housing
• 24-VDC power supply
Description
The GS33910060800 is a Profinet gateway with a
built-in 2-port switch.
The module has no settings and works only in
association with the master generator GS3390
0000 800.
By installing the GSD file in the PLC, the installer
can design the functionallity of e.g. digital in/out,
analink, mux BCD and Dupline® safe signals.
After installation and connection it is possible, by
using the mini webserver, to perform tests and
diagnostics on both Profinet and the Dupline®
networks (up to 7 Dupline® networks)
Applications
Any application with the use of digital in/out, analink, MUX BCD, Dupline® Safe and Profinet
Main functions
• Gateway between Dupline® and Profinet
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 1
GS33910060800
Features
Power Supply
Power supply 24 VDC +/- 20%
Overvoltage category Overvoltage category II (IEC 60664-1, par. 4.3.3.2)
Rated impulse withstand voltage 500V (1,2/50µs) (IEC 60664-1, tab. F.1)
Rated operational power 2.8 W
Reverse-polarity protection Yes
Connection A1 (+) and A2 (-)
Power-ON delay Typ. 4 s
Power-OFF delay ≤1s
Power supply to Ethernet bus 500 V impulse (1.2/50us) 500 V AC for 1 min
Communication Profinet
Conformance Class B
• RT_Class 1
• UDP/IP-Comm
• LLDP-Frames
• Alarms
• SNMP-support
• LLDP-MIB
Performance Characteristics
• 100 Mbps, full duplex with auto negotiation enabled as default
• Real Time (RT) communication, 250 µs cycle time
Data
• Up to 128 subslots in total
• 1440 bytes of IO data in each direction, including status bytes
Environmental
Front IP50
Degree of protection
Screw terminal IP20
Pollution degree 2 (IEC 60664-1, par. 4.6.2)
Operating temperature -20°... +50°C (-4°... +122°F)
Storage temperature -50° ... +85°C (-58° ... +185°F)
Humidity (not condensing) 20 ... 80% relative humidity
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 2
GS33910060800
EMC
Immunity EN61000-6-2
Emission EN61000-6-3
Indication
LED description
Name Colour Behaviour
HS-BUS Yellow ON: Bus OK, OFF: Bus not OK
Error Red ON: Error detected, OFF: No error
ON: Bus OK, OFF: Bus not OK, Flashing: when the PLC
Profinet Communication Red
requests it
ETH1:RJ45 Link1 Green ON: Cable connected, OFF: Cable disconnected
EHT1: RJ45 Activity1 Yellow Flashing: communication
ETH2:RJ45 Link2 Green ON: Cable connected, OFF: Cable disconnected
EHT2: RJ45 Activity2 Yellow Flashing: communication
Power supply Green ON: Supply ON, OFF: Supply OFF
LED Profinet
LED status Description Comments (*)
OFF Offline No power, No connection with IO controller
Connection with IO Controller established, IO Controller in
ON Online (RUN)
RUN state
Connection with IO Controller established, IO Controller in
1 flash Online (STOP)
STOP state or IO data bad, IRT synchronization not finished
Blinking Blink Used by engineering tools to identify the node on the network
(*)Test sequences are performed on the network and module status LEDs during startup
Error LED indication
LED status Description Comments (*)
ON Fatal event Major internal error
1 flash Station name error Station name not set
2 flashes IP address error IP address not set
3 flashes Configuration error Expected Identification differs from Real Identification
(*)Test sequences are performed on the Network and module-status LEDs during startup
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 3
GS33910060800
Mechanics
Housing
Housing material Noryl
Colour Light grey
Dimensions (HxWxD) 90 x 35 x 58.5 mm
Weight 110 g
35
.0
90.0
90.0
45.0
5.0
45.0
5.0
35.0 44.0 14.5
.0
44
.5
14
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 4
GS33910060800
Wiring
+
A
-
A1 A2
(+) (-)
BUS
ERROR
PROFINET
ETH2
ETH1
ON
Dupline
ETH1
PROFINET
ETH2
ETH1 B ETH2
A 24-VDC Supply B Ethernet switch
Connection
Terminal 2-screw type
Cable cross-section area max. 1.5 mm2
Tightening torque 0.4 Nm / 0.8 Nm
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 5
GS33910060800
Example of an installation with two MCG networks
A B
E
D
A Profinet D Profinet gateway (Ethernet module)
MCG1+2 (up to 7 connected to one Profinet
B E Dupline® & Dupline®Safe
gateway)
C Siemens S7 PLC
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 6
GS33910060800
Compatibility and conformity
Approvals
CE-marking
Approvals UL60950
UL notes:
Max ambient temperature: 40°C
Equipment must be supplied by a separately certified NEC class 2 (LPS) power unit
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 7
GS33910060800
Mode of operation
Mode of operation
The GS3391 0060 800 is a Profinet gateway with the function as a slave.
The module has a 2-port Ethernet switch RJ45 for connection to Profinet.
The module is to be mounted in association with the master generator GS3390 0000 800, to which up to 7
master generators can be connected.
Each master generator can operate with 128 Dupline® addresses.
All Dupline® signals from the master generator are available on Profinet.
By using the GSD file in the PLC configuration tool, the installer can design the functionallity of e.g digital in/
out, analink, mux BCD and Dupline® safe signals.*
After installation and connection it is possible, by using the mini webserver, to perform tests and run diagnostics
on both profinet and the Dupline® networks (up to 7 Dupline® networks).
The Profinet gateway is equipped with LEDs to show communication status.
* The GSD file can be downloaded from: Productselection.net
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 8
GS33910060800
References
Product selection key
GS33910060800
COPYRIGHT ©2016
Content subject to change. Download the PDF: www.productselection.net
30/09/2016 GS33910060800 ENG Carlo Gavazzi Industri A/S 9
