Scribd
Upload
27 views2 pages

Oven

This safety operation procedure provides guidance for operating an oven in the Aeronautics Laboratory at the Faculty of Mechanical Engineering safely. The procedure outlines how to open and close the oven door, switch the oven on and set the temperature, control air flow, and use proper personal protective equipment like gloves and laboratory coats. Emergency procedures require at least two people to transport the oven and to stop all experimental activity and seek help if an emergency occurs.

Uploaded by

Nor Fhairna
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
27 views2 pages

Oven

This safety operation procedure provides guidance for operating an oven in the Aeronautics Laboratory at the Faculty of Mechanical Engineering safely. The procedure outlines how to open and close the oven door, switch the oven on and set the temperature, control air flow, and use proper personal protective equipment like gloves and laboratory coats. Emergency procedures require at least two people to transport the oven and to stop all experimental activity and seek help if an emergency occurs.

Uploaded by

Nor Fhairna
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

utm/oshe/sop/v01

SAFETY OPERATION PROCEDURE


Faculty/Department/Unit FKM Title : Oven Procedure
Room Monitoring Room
Location/Block P20 No of Revision :
Clasification Date of
Revision:

1. Scope:

This procedure is used to perform chemical activity in Aeronautics Laboratory Faculty of


Mechanical Engineering.

2. Objective:

To provide guidance and procedures work properly and safely to prevent injury to the
body's internal and external members.

3. Reference Documents:

3.1. Occupational Safety and Health Act 1994 - (Section 15 (2) (b), required employers and
self-employed persons. Employers must create a safe workplace and healthy not only for
employees, but also for the general public.

3.2. Standard Operating Procedure for welding safety, welding in confined spaces, handling
of compressed gases, fire and electrical safety, ventilation, protective equipment, and
worker training OSHE UTM.

4. Oven Procedure

4.1. Operating the door


4.1.1. The door is opened by pulling on the door handle.
4.1.2. The door is closed by the door handle being pushed in.

4.2. Switching On
4.2.1. The oven is switched on by pressing the push/turn control.

1daripada 1
utm/oshe/sop/v01

4.3. Setting Air Change


4.3.1. Moving the air slider opens and closes the air valve to control the supply and
discharge of air.

4.4. Setting the Temperature.


4.4.1. Hold down the SET key and set the temperature setpoint with the push/turn
control.
4.4.2. After the SET key has been released the display briefly flashes the temperature
setpoint.
4.4.3. The display then changes to the actual current temperature and the controller starts
to control to the selected temperature setpoint.

5. Personal Protective Equipment

Protective Clothing: Laboratory coat and gloves

6. Emergency

6.1. Always use gloves. If the oven has to be carried, at least 2 persons are required to
transport it.

6.2. Stop all activity of experimental if any emergency happened, stay in the safe place
and seek medical help.

Prepared by: Reviewed by (Setiausaha KKP): Verified by (Pengerusi KKP):


maizatul
(Siti Maizatul Farhain)
Pelajar

(Abd Basid Abd Rahman)


Jurutera

Date: 27/03/2016 Date: Date:

2daripada 1

You might also like