9) Do not defeat the safety purpose of the
4-480-527-13(1)
polarized or grounding-type plug. A General information
polarized plug has two blades with one
wider than the other. A grounding type
plug has two blades and a third grounding
prong. The wide blade or the third prong Troubleshooting
FM/AM Clock Radio are provided for your safety. If the provided
plug does not fit into your outlet, consult an
Should any problems persist after you ha
made the following checks, consult your
electrician for replacement of the obsolete
Operating Instructions nearest Sony dealer.
outlet.
10) Protect the power cord from being walked The clock flashes “AM 12:00” after
on or pinched particularly at plugs, power interruption.
convenience receptacles, and the point
The battery is discharged. Remove the
where they exit from the apparatus. battery and insert a new one.
11) Only use attachments/accessories specified
by the manufacturer. Unsatisfactory reception
12) Use only with the cart, stand, tripod, The AC power cord functions as an FM
bracket, or table specified by the antenna. Extend the AC power cord ful
manufacturer, or sold with the apparatus. increase reception sensitivity.
When a cart is used, use caution when
moving the cart/apparatus combination to
avoid injury from tip-over.
©2014 Sony Corporation Printed in China
ICF-C1
13) Unplug this apparatus during lightning Rotate the unit horizontally for optimu
reception. A ferrite bar AM antenna is b
storms or when unused for long periods of
into the unit.
time.
Before operating the unit, please read this 14) Refer all servicing to qualified service
guide thoroughly and retain it for future personnel. Servicing is required when the
reference. apparatus has been damaged in any way,
such as power-supply cord or plug is
For customers who purchased this This symbol is intended to alert the damaged, liquid has been spilled or objects
product in the USA user to the presence of uninsulated have fallen into the apparatus, the
Please register this product on line at “dangerous voltage” within the apparatus has been exposed to rain or
http://www.sony.com/productregistration. product’s enclosure that may be of Do not operate the unit over a steel de
moisture, does not operate normally, or has metal surface, as this may lead to
Proper registration will enable us to send sufficient magnitude to constitute a been dropped.
you periodic mailings about new products, risk of electric shock to persons. interference.
services, and other important
This symbol is intended to alert the The radio or buzzer alarm does no
announcements. Registering your product For the state of California, USA
user to the presence of important sound at the preset alarm time.
will also allow us to contact you in the
operating and maintenance (servicing) only
unlikely event that the product needs
instructions in the literature Check that “ ” appears on the display
adjustment or modification. Thank you. Perchlorate Material –special handling may
accompanying the appliance. The radio alarm is activated but no
apply, See sound is emitted at the preset ala
www.dtsc.ca.gov/hazardouswaste/perchlorate
NOTE time.
WARNING Perchlorate Material: Lithium battery contains
Adjust the volume using VOLUME +/–.
This equipment has been tested and found to perchlorate
To reduce the risk of fire or electric shock, do comply with the limits for a Class B digital When daylight saving time (summ
not expose this apparatus to rain or time) begins, the clock does not sw
moisture.
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
Precautions to daylight saving time (summer t
To reduce the risk of fire, do not cover the reasonable protection against harmful Operate the unit on the power sources automatically.
interference in a residential installation. This specified in “Specifications.”
ventilation of the apparatus with newspapers, Make sure the clock is set correctly.
tablecloths, curtains, etc. And do not place equipment generates, uses and can radiate To disconnect the power cord (mains lead),
pull it out by the plug, not the cord. When “Aut On” appears on the disp
lighted candles on the apparatus. radio frequency energy and, if not installed and after pressing and holding DST for mo
To reduce the risk of fire or electric shock, do used in accordance with the instructions, may Do not leave the unit in a location near a
3 seconds, the Automatic DST/summe
cause harmful interference to radio heat source, such as a radiator or airduct, or
not expose this apparatus to dripping or function becomes active.
communications. However, there is no in a place subject to direct sunlight, excessive
splashing, and do not place objects filled with
guarantee that interference will not occur in a dust, mechanical vibration, or shock.
liquids, such as vases, on the apparatus.
Allow adequate air circulation to prevent
Do not install the appliance in a confined
particular installation. If this equipment does
cause harmful interference to radio or internal heat build-up. Do not place the unit Specifications
space, such as a bookcase or built-in cabinet. on a surface (a rug, blanket, etc.) or near
television reception, which can be determined
Do not expose batteries or apparatus with by turning the equipment off and on, the user materials (a curtain) that might block the Time display
battery-installed to excessive heat such as is encouraged to try to correct the interference ventilation holes.
12-hour system
sunshine, fire or the like. by one or more of the following measures:
— Reorient or relocate the receiving NOTES ON LITHIUM BATTERY
As the main plug is used to disconnect the unit
antenna. Frequency range
from the mains, connect the unit to an easily Wipe the battery with a dry cloth to assure a
— Increase the separation between the good contact.
accessible AC outlet. Should you notice an Band Frequency
equipment and receiver.
abnormality in the unit, disconnect the main Be sure to observe the correct polarity when FM 87.5 MHz – 108 MHz
— Connect the equipment into an outlet on installing the battery.
plug from the AC outlet immediately. a circuit different from that to which the AM 530 kHz – 1,710 kHz
receiver is connected. Do not hold the battery with metallic
The unit is not disconnected from the AC tweezers, otherwise a short-circuit may
power source (mains) as long as it is connected — Consult the dealer or an experienced
occur.
to the wall outlet, even if the unit itself has radio/TV technician for help. Speaker
Do not expose the battery to excessive heat
been turned off. such as direct sunlight, fire or the like. Approx. 6.6 cm (2 / inches) dia., 8 Ω
The nameplate and important information WARNING If you have any questions or problems
concerning safety are located on the bottom concerning your unit, please consult your Power output
exterior. Do not ingest battery, chemical burn
nearest Sony dealer. 100 mW (at 10% harmonic distortion)
hazard.
You are cautioned that any changes or
This product contains a coin/button cell
modifications not expressly approved in this
battery. If the coin/button cell battery is
Power requirements
manual could void your authority to operate 120 V AC, 60 Hz
swallowed, it can cause severe internal burns in
this equipment. For power backup: 3 V DC, one CR2032 b
just 2 hours and can lead to death.
Keep new and used batteries away from
CAUTION children. If the battery compartment does not Dimensions
Danger of explosion if battery is incorrectly close securely, stop using the product and keep Approx. 101 mm 102 mm 101 mm (w/
replaced. Replace only with the same type. it away from children. (4 inches 4 inches 4 inches) includin
If you think batteries might have been projecting parts and controls
swallowed or placed inside any part of the
body, seek immediate medical attention.
Mass
Approx. 480 g (1 lb 1 oz) including CR2032
Important Safety Instructions battery
1) Read these instructions. Design and specifications are subject to
2) Keep these instructions. change without notice.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings.
Install in accordance with the
manufacturer’s instructions.
8) Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that
produce heat.
