Scribd
Upload
26 views2 pages

TMP102 Ejemplo de Cableado y Aplicacion

This document provides an example of using the Wire library to read temperature data from a TMP102 temperature sensor. It demonstrates initializing the Wire library using the SCL and SDA pins, requesting a reading from the sensor over I2C, receiving the two bytes of data, and calculating the temperature in Celsius. The sensor address is 0x91 but only the 7 most significant bits are used by the Wire library.

Uploaded by

Juan Araujo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views2 pages

TMP102 Ejemplo de Cableado y Aplicacion

This document provides an example of using the Wire library to read temperature data from a TMP102 temperature sensor. It demonstrates initializing the Wire library using the SCL and SDA pins, requesting a reading from the sensor over I2C, receiving the two bytes of data, and calculating the temperature in Celsius. The sensor address is 0x91 but only the 7 most significant bits are used by the Wire library.

Uploaded by

Juan Araujo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

EJEMPLO DE CABLEADO Y APLICACION

This example is for Wiring version 1.0 build 0100+. If you have a previous version, use the
examples included with your software. If you see any errors or have comments, please let us know.
tmp102 temperature sensor by BARRAGAN (http://barraganstudio.com)

Demonstrates use of the Wire library reading data from the tmp102 temperature sensor On
Wiring v1 boards the SCL and SDA pins are: 0 and 1 On

Wiring S board the SCL and SDA pins are: 8 and 9


#include <Wire.h>

// From the datasheet the BMP module address LSB distinguishes

// between read (1) and write (0) operations, corresponding to


// address 0x91 (read) and 0x90 (write).

// shift the address 1 bit right (0x91 or 0x90), the Wire library only needs the 7

// most significant bits for the address 0x91 >> 1 = 0x48

// 0x90 >> 1 = 0x48 (72)

int sensorAddress = 0x91 >> 1; // From datasheet sensor address is 0x91

// shift the address 1 bit right, the Wire library


only needs the 7

// most significant bits for the address

byte msb;

byte lsb;

int temperature;

void setup(){

Serial.begin(9600); // start serial communication at 9600bps

Wire.begin(); // join i2c bus (address optional for master)

void loop(){

// step 1: request reading from sensor

Wire.requestFrom(sensorAddress,2);
if (2 <= Wire.available()) // if two bytes were received

{
msb = Wire.read(); // receive high byte (full degrees)

lsb = Wire.read(); // receive low byte (fraction degrees)

temperature = ((msb) << 4); // MSB

temperature |= (lsb >> 4); // LSB


Serial.print("Temperature: ");

Serial.println(temperature*0.0625);

}
delay(500); // wait for half a second

You might also like