Scribd
Upload
78 views2 pages

Straightening Process Report

This straightening report summarizes the straightening of a part. It documents the equipment used, initial and final run out measurements before and after straightening, and determines if the part was accepted or rejected based on the specified acceptable run out limits. The part number, customer information, model, and references are listed. Measurement readings are shown at 0, 90, 180, and 270 degrees. Sign-off from the QC engineer, inspector, and operator is included.

Uploaded by

Irwanto Manaf
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
78 views2 pages

Straightening Process Report

This straightening report summarizes the straightening of a part. It documents the equipment used, initial and final run out measurements before and after straightening, and determines if the part was accepted or rejected based on the specified acceptable run out limits. The part number, customer information, model, and references are listed. Measurement readings are shown at 0, 90, 180, and 270 degrees. Sign-off from the QC engineer, inspector, and operator is included.

Uploaded by

Irwanto Manaf
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 2

Document No.

: QAR-QD#407-1
Revision : 00
STRAIGHTENING REPORT Date : 2-Oct-06
Responsibility : QC Department
Page : 1 of 1

No. : Customer : Part Name :

SO. No. : Location : Model :

SSB-ID : Cust. WO. No. : Part No. :


REFERENCES :
1. GUIDELINE FOR REUSABLE PARTS AND SALVAGE OPERATIONS : SEBF8072-06 March 2000
2. HVOF SPRAY BULLETIN : HVOF1010-02 MP-5 (12/00)
EQUIPMENT USED :
1. EITEL STRAIGHTENING PRESS (MODEL RP160, SERIAL NO. 25960, CAPACITY 160 TONS)

0 A B C D E F
0 0°

270° 90°

180°
L

ROD LENGTH ( L ) = ……………….. mm (inch)


ACCEPTABLE RUN OUT FOR STRAIGHTENING PROCESS : < 3.18 / 610 mm (0.125 / 24.0 in) x ……….…..mm (inch) = ……....….. mm (inch)
INITIAL RUN 0UT MEASUREMENT (CENTER TO CENTER)
A B C D E NOTE
0O

90O
180O
270O

INITIAL RUN 0UT MEASUREMENT (WITH ROLLER)


A B C D E F
0O
90O
180O
270O
NOTES :
*) ACCEPTABLE RUN OUT FOR HVOF SALVAGE PROCESS < 0.076 mm EYE IS ALIGNED WITH ROD YES NO
*) ACCEPTABLE RUN OUT FOR HARD CHROME PLATING SALVAGE PROCESS < 0.376 mm JUDGMENT ACC REJECT
*) ACCEPTABLE RUN OUT FOR OVERALL RODS WITHOUT SALVAGE PROCESS < 0.360 mm
*) ACCEPTABLE RUN OUT FOR OVERALL RODS THAT WILL BE REBUILD BY WELD < 0.760 mm
*) STRAIGHTENING IS NOT APPLICABLE FOR ROD AS STEERING CYLINDER,
SCRAPER BOWL AND FRONT SUSPENSION ROD
FINAL READING AFTER STRAIGHTENING
A B C D E F

JUDGMENT : ACC REJECT


Reviewed by Checked by Executed by
QC Engineer : Inspector : Operator :
Signature : Date Signature : Date Signature : Date
FT-SSBR-BLP-QAP-015-QC-003

You might also like