Scribd
Upload
17 views8 pages

Networking Commands 2

The document lists and describes 11 common networking commands including hostname, ipconfig, arp-a, netstat, ping, route print, tracert, pathping, getmac, and ping -t. These commands are used to display system information like IP addresses, routing tables, and trace network routes.

Uploaded by

riyasainwal123
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
17 views8 pages

Networking Commands 2

The document lists and describes 11 common networking commands including hostname, ipconfig, arp-a, netstat, ping, route print, tracert, pathping, getmac, and ping -t. These commands are used to display system information like IP addresses, routing tables, and trace network routes.

Uploaded by

riyasainwal123
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

1

NETWORKING COMMANDS
1. Hostname :-
 It display the name of your computer.

2. Ipconfig :-
 It display information about host TCP/IP
configuration.
2

3. Ipconfig/all :-
 This command displays detailed configuration
information about your TCP/IP connection including
Router, Gateway, DNS, DSCP, and type of ethernet
adapter in your system.
3

4.arp-a :-
 ARP stands for Address Resolution Protocol it will
show IP address of your computer along with IP
address and MAC address of your router.
4

5.Netstat :-
 Netstat display a variety of statistics about a
computer’s active TCP/IP connection.

6.Ping (Default gateway):-


 Ping is used to request a communication to another
computer fast as making a phone call using its IP
address.
5

7.Route print :-
 The route print command displays the computer’s
routing table.
6

8.Tracert :-
 The tracert command display a list of all routers that
a packet has to go through to get from the computer
where you are setting and tracert is run to any other
computer on the internet.

9.Pathping :-
 It is a combination of ping and tracert command.
Pathping tracert the route to destination address
and then launches a 25 second test of each route
along the way gathering statistics the rate of data
loss along each loop.
7

10. Getmac:-

 It is used to display the MAC address for each network


adapter in the computer.

11.Ping(Default gateway) -t:-


 This ping command option will ping the target until you
stop it by pressing Ctrl-C.
8

You might also like