Scribd
Upload
46 views1 page

15" Bass Guitar Woofer Specifications

This document provides specifications for a 15-inch bass guitar woofer. It lists technical details like impedance, power handling, sensitivity, frequency response range, and dimensions. The woofer has a ferrite magnet, steel basket, 2-inch copper voice coil, and is rated for 400 watts of program power handling.

Uploaded by

stefanogozzi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
46 views1 page

15" Bass Guitar Woofer Specifications

This document provides specifications for a 15-inch bass guitar woofer. It lists technical details like impedance, power handling, sensitivity, frequency response range, and dimensions. The woofer has a ferrite magnet, steel basket, 2-inch copper voice coil, and is rated for 400 watts of program power handling.

Uploaded by

stefanogozzi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

FBASS15-20

15” BASS GUITAR WOOFER


FERRITE MAGNET
STEEL BASKET DRIVER

- 2 INCH COPPER VOICE COIL


- 98 dB/SPL SENSITIVITY
- 400 WATT PROGRAM POWER HANDLING
- TRIPLE ROLL SURROUND
- OVERALL BALANCED AND RICH TONE
- SOLID LOW-END AND TIGHT MID-HIGH’S

GENERAL SPECIFICATIONS FREQUENCY RESPONSE


Nominal diameter mm (in.) 380 (15)
Nominal impedance Ω 8
Minimum impedance Ω 5,9
SPL (dB) @ 2.83V, 1m, half space

Program power (1) W 400


AES Power rating (2) W 200

Impedance (Ohm)
Sensitivity (3) dB 98
Frequency range Hz 40 ÷ 4000
Voice coil diameter mm (in.) 51 (2)
Chassis material Steel
Magnet material Ferrite
Magnet dimensions mm 140 x 60 x 17
OD x ID x h (in.) (5.5 x 2.36 x 0.67)
Coil material Copper
Former material Glass fiber
Cone material Water Proof Treated Paper
Surround material Polycotton Frequency (Hz)
Xmax (4) mm (in.) 4,3 (0.17)
Xmech (5) mm (in.) 8,4 (0.33)
DIMENSIONS mm (in.)
Gap height mm (in.) 8,2 (0.32)
Voice coil winding height mm (in.) 12,6 (0.5)
Driver displacement volume l (ft3) 3 (0.1)

SMALL SIGNAL PARAMETERS


DC resistance Re Ohm 5,3
Resonance frequency Fs Hz 40
Moving mass Mms g (oz) 70 (2.47)
Compliance Cms mm/N 0,23
Force factor BxL N/A 12,8
Mechanical Q-factor Qms 8,7
Electrical Q-factor Qes 0,56
Total Q-factor Qts 0,53
Equivalent air volume Vas l (ft3) 234 (8.26)
Voice coil Inductance Le mH 0,70
Diaphragm area Sd cm2 (in.2) 855 (132.53)
Reference efficiency Eta 0 % 2,50
(1) Program power is defined as 3 dB greater than AES Power. (2) Tested for two hours using a
continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested
SHIPPING INFORMATION in free air. (3) From T/S parameters, measured with Klippel DA LPM module. (4) The Xmax is
calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height. (5) The
Net weight kg (lb.) 4,1 (9.1) Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
Multipack size (1) mm 438 x 438 x 204 (6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity
WxDxH (in.) (17.2 x 17.2 x 8) for 2 hours; b) by Klippel LSI measurement.
Multipack weight kg (lb.) 6,2 (13.6) All specifications subject to change without notice_B.a

WWW.LAVOCESPEAKERS.COM Lavoce Italiana


[email protected] [email protected] 151

You might also like