Scribd
Upload
164 views1 page

D.Fab 3D .1.00: Plasticiser/Superplasticiser

The document provides technical data and information about D.FAB 3D α.1.00, a plasticiser and superplasticiser for concrete. It details characteristics such as density, chloride content, and recommended dosage. Effects on workability and retardation are also discussed. Instructions for storage and applications are provided.

Uploaded by

hello.mjr94
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
164 views1 page

D.Fab 3D .1.00: Plasticiser/Superplasticiser

The document provides technical data and information about D.FAB 3D α.1.00, a plasticiser and superplasticiser for concrete. It details characteristics such as density, chloride content, and recommended dosage. Effects on workability and retardation are also discussed. Instructions for storage and applications are provided.

Uploaded by

hello.mjr94
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

December 2020

TECHNICAL DATASHEET

D.FAB 3D α.1.00
Plasticiser/Superplasticiser
CHARACTERISTICS ADMISSION
D.FAB IIID α.1.00 is a concrete plasticiser and a  D.FAB IIID α.1.00 is permanently subject to internal
superplasticiser with very good plasticising and factory production controls
homogenising as well as low cement dependent
retarding effect.  D.FAB IIID α.1.00 corresponds to the regulations of
EN 934-1 and EN 934-2, Tab. 2, 3.1 + 3.2
TECHNICAL DATA
Density (20 °C): 1,20 ± 0,03 g/cm³ STORAGE
Cl-Content: ≤ 0,10 M.-% Storage life is 12 months from date of manufacture if
Na2O-equivalent: ≤ 8,50 M.-% stored correctly (tightly closed at > +5 °C):
Color and form: brown liquid  Keep storage containers and tanks tightly closed
Recommended range
of dosage : 0,2 – 2,0 M.-% by weight of  Protect product from frost, heat and direct
cement sunlight

EFFECTS
Plasticising effect

Workability retention

Retardation
CONTACT
CEMEX Admixtures GmbH
Early strength
Geseker Straße 31–33
0 2 4 6 8 10 33154 Salzkotten
Germany
The information in this table refers to the active substance type without Tel. +49 5258 9858-0
consideration of the active ingredient content.
[email protected]
APPLICATION www.admixtures.de
 D.FAB 3D α.1.00 is a plasticiser to be used in
combination D.FAB 3D β.1.00 for 3D printing
applications.

www.admixtures.de

Copyright © 2020 CEMEX Trademarks Holding Ltd. All rights reserved.


Note: The raw materials used and the products manufactured by us are submitted to precise plant control. The content of our technical leaflet is
based on three decades of experience, research and technical back up. Due to continuous development and varying applications we reserve the
right to revise and improve our product. Our technical department and experts are available to give assistance on request. An advantage you should
make use of!

You might also like