Scribd
Upload
50 views1 page

Teak Oil with Wax for Outdoor Wood

This technical data sheet provides information on an oil for teak wood with wax. The document details the product's main properties, versions, suggested use, application method, chemical and physical characteristics, application characteristics, substrate preparation, and general remarks.

Uploaded by

Radu Dinulescu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views1 page

Teak Oil with Wax for Outdoor Wood

This technical data sheet provides information on an oil for teak wood with wax. The document details the product's main properties, versions, suggested use, application method, chemical and physical characteristics, application characteristics, substrate preparation, and general remarks.

Uploaded by

Radu Dinulescu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TECHNICAL DATA SHEET Version 2 of 02/10/2009

AS---M006
Oil for teak – with wax

Main properties:
 Mixture of oils with excellent revitalizing and  Easy to apply

Renner Italia S.p.A. via Ronchi Inferiore,34 – 40061 Minerbio, Bologna Italy Tel +39.051.6618211 Fax +39.051.6606312 [email protected] www.renneritalia.com
waterproofing properties  Wax grants a silky result and strong water-
 It ideally suits for coating and curing garden repellent properties
furniture and wooden substrates against  It contains UV absorbers which prolong
atmospherical agents (for ex. Outdoor floors, duration of coat and enhance the protection
bowers) of wood
 Formulated for difficult to cure wood, like  Easy to treat and mantain
teak
 Excellent permeating properties

Versions:
/----- clear

Suggested use: Coating and curing of furniture for exteriors


Application method: by wipe
Product preparation: ready to use

Chemical – phisical characteristics Application characteristics


Solid content (%) 58 ± 1 Number of coats 1
3 2
Specific weight (g/cm ) 0,840 ± 0,030 Suggested quantity max: 20 g/m
2
Viscosity 23°C (DIN 4) 17 +/- 1 Spreading rate 40 - 50 m /kg

Drying at 20°C and RU% between 45 & 65: 50 g/m2


Dust free 4h
Touch free 16 h
Overcoating with same product 24 h minimum

Substrate preparation: clean very well the surface with a wet wipe, then dry. In case of need, sanding the
raw surface with paper grit 150. AS---M006 shall be directly apply by wipe, spreading very well. In case of
application on already coated substrates, we recommend to sand the substrate in order to remove the old
coat .

General remarks

Product has unlimited shelf life

Page 1 of 1 Printed on 22/10/2014


DATA PROVIDED ON THIS TECHNICAL DATA SHEET CORRESPOND TO OUR BEST KNOWLEDGE AND EXPERIENCE. HOWEVER THE RESPONSIBILITY OF FINAL RESULTS OF COATING SYSTEM
RESTS ENTIRELY WITH THE USERS, WHO SHALL MAKE SURE THAT THE PRODUCT IS IN COMPLIANCE WITH THE REQUIREMENT OF THE APPLICATION SYSTEM, THE SUBSTRATES USED AND
THE WORKING CONDITIONS.

You might also like