SPECIFICATION

NIPPON PAINT WATERPROOFING SYSTEM

Item Location Specification Description Unit Rate (RM)

Level: Waterproofing Crystallization Admixture

Lowest Level Supply & dosed “Nippon Paint” “NippoMIX WP100” crystallization M3 65.00
waterproofing admixture at a rate of 0.8% per 100kg cementitious
content. Requirement a minimum cement content 350kg/M3 and
maximum W/C of 0.5 all accordance to manufacturer’s specification
and instruction.

Damp proofing membrane

Supply and lay “NippoGARD DPM” LDPE 0.25mm membrane for M2 8.00
damp proofing

To seal all construction joints with "NippoJOINT” CJ25E, 250 mm Supply Only
wide PVC waterstop RM520/15m)

Level: Lift Pit

Lift Pit Supply and apply “Nippon Paint” 3 coats “NippoSEAL Interbit”
bituminous liquid applied membrane at the rate of 0.6kg/m2/coat all M2 28.00
accordance to the manufacturer’s (Nippon Paint (M) Sdn Bhd)
specification and instruction.

To be protected with 15mm thick. Expanded polystyrene protective M2

board / geotextile separation sheet prior to back-filling By others

To seal all construction joints with “NippoJOINT CJ20C”, 200mm M (Supply only
wide PVC waterstop RM480/15m)

Level: Internal Wet Area

Toilet, Bath, Supply and apply “Nippon Paint” 2 coats “NippoCEM Flex” flexible
Yard, Refuse, cementitious waterproofing at the rate of 1.0kg/m2/coat all
A/C, Balcony, accordance to manufacturer’s (Nippon Paint (M) Sdn Bhd) M2 20.00
CW, HR, WR specification and instruction.
Pump Room,
Changing Room, Upturn 300mm including 25mm angle fillet (R.C Shear Wall) M 6.00
Ablution
Upturn 1500mm shower wall including 25mm angle fillet M 30.00
(Conventional Brick & Plaster Wall)
*Shower wall upturn at 300mm is sufficient for shear wall

Treat RWDP pipe with one layer “NippoSEAL Flex 100” Nos. 10.00

Note: Waterproofing system required to be protected with min. 50mm

thick cement sand (1:3) and a gradient to fall (1:120), all in By others
accordance to manufacturer’s specification and instruction.
Level: Water Retaining Structure

Cold Water RC Supply and apply “Nippon Paint” 3 coats “NippoCEM Flex”
Suction Tank, cementitious waterproofing at the rate of 1.0kg/m2/coat all
OSD RC Tank accordance to manufacturer’s (Nippon Paint (M) Sdn Bhd)
Rainwater specification and instruction.
Harvesting To slab and wall including 25mm angle fillet M2 28.00
Water Feature
Supply & dosed “Nippon Paint” “NippoMIX WP100” crystallization
waterproofing admixture at a rate of 0.8% per 100kg cementitious
content. Required minimum cement content 350kg/M3 and
maximum W/C of 0.5 all accordance to manufacturer’s (Nippon
Paint (M) Sdn Bhd) specification and instruction.
To slab and wall M3 65.00

P a g e 1|2
 SPECIFICATION
To seal all construction joints with "NippoJOINT CJ20C”, 200mm (Supply only
wide PVC waterstop RM480/15m)

Note: Waterproofing system required to be protected with min. 50mm

thick cement sand all in accordance to manufacturer’s specification
and instruction.

Level: R.C Roof / Exposed Area / Landscape

RC Flat Roof Supply and apply “Nippon Paint” 2 coats “NippoSEAL Flex 100”
RC Planter Box high build, thixotropic polyurethane liquid applied membrane
BBQ Pit, reinforced with “LM Mat” Chopped Strand Fiber Mesh at the rate of
Pool Deck, 0.75kg/m2/coat all accordance to the manufacturer’s (Nippon Paint M2 38.00
Artificial Turf, (M) Sdn Bhd) specification and instruction.
Landscape
Upturn 300mm including 25mm angle fillet M 11.40

Treat RWDP pipe with one layer “NippoSEAL Flex 100” Nos. 15.00
To be protected with min. 50mm thick concrete chipping with BRC A6
to engineer's details, all in accordance to manufacturer’s specification
and instruction.

Note: By others
R.C roof to form surface contraction joints on concrete chipping with
12.5mm width x 25mm depth groove to be introduced at every 1.5m
x 1.5m span with filled with high performance PU sealant to groove.

Level: Swimming Pool

Swimming Pool, Supply and apply “Nippon Paint” 3 coats “NippoCEM Flex”
Wading Pool, cementitious waterproofing at the rate of 1.0kg/m2/coat reinforced
Jacuzzi with “CM Mat” alkali resistant glass fibre mesh all accordance to
manufacturer’s (Nippon Paint (M) Sdn Bhd) specification and
instruction. M2 32.00
To slab and wall including 25mm angle fillet

Supply & dosed “Nippon Paint” “NippoMIX WP100” crystallization

waterproofing admixture at a rate of 0.8% per 100kg cementitious
content. Required minimum cement content 350kg/M3 and
maximum W/C of 0.5 all accordance to manufacturer’s specification
and instruction. M3 65.00
To slab and wall

To seal all construction joints with "NippoJOINT CJ20C”, 200mm (Supply only
wide PVC waterstop RM480/15m)

Note: Waterproofing system required to be protected with min. 50mm

thick cement sand all in accordance to manufacturer’s specification By others
and instruction.

Car Park Floor Specification

Level: Natural Floor Hardener

Carpark To supply & lay " Nippon Paint Hardtop” non-metallic surface
hardener used at rate of 4kg/m2 laid monolithically trowelled to be
desired finish and cure with " Nippon Paint Cure P” curing
compound. To floor; laid to falls and at the rate of 4 kg/m2 and
power floated smooth.

To floor M2 10.50

To ramp (groove) M2 30.00

P a g e 2|2