ANUBOSE INSTITUTE OF TECHNOLOGY
KSP ROAD, PALONCHA- 507115
(Approved by AICTE, New Delhi, Affiliated to JNTU, Hyderabad)
II MID Term Examinations, SEP - 2023
Course: II-B.Tech-ECE Subject Name: ECA
Answer any TWO questions 2*5=10M
1. Write briefly about Hartely oscillator.
2. Discuss briefly about Wein bridge oscillators.
3. Write down about Class-A power amplifier and its two types.
4. Write down briefly about Astable Multivibrator.
ANUBOSE INSTITUTE OF TECHNOLOGY
KSP ROAD, PALONCHA- 507115
(Approved by AICTE, New Delhi, Affiliated to JNTU, Hyderabad)
II MID Term Examinations, SEP - 2023
Course: II-B.Tech-ECE Subject Name: ECA
NAME OF THE STUDENT:________ ______________H.T
NUMBER:
Answer any ALL questions MAX.MARKS: 10
1. Which of these is not true for a class B amplifier[ ]
a) It has zero DC bias
b) They have an efficiency less than that of class A amplifiers
c) The quiescent power dissipation is zero
d) The conduction angle is only 180°
2. What is the output of a class B amplifier for sinusoidal input [ ]
a) Sinusoidal amplifier
b) Half-sinusoidal
c) Sinusoidal with higher frequency
d) Square wave
3. RC phase shift oscillators contain a minimum of _________ Phase shift network[ ].
a) 1
b) 2
c) 3
d) 0
4. One phase shift network of an RC phase shift oscillator contain __________ capacitor[ ].
a) 1
b) 2
c) 3
d) 0
5. One phase shift network of an RC phase contain __________ resistor[ ].
a) 1
b) 2
c) 3
d) 0
6. Phase shift provided by one phase shift network in RC phase shift oscillator in 3 stage is
___________[ ]
a) 180 degrees
b) 60 degrees
c) 120 degrees
d) 90 degrees
7. Which type of feedback is used by Colpitts oscillato[ ]r
a) Voltage series feedback
b) Current series feedback
c) Voltage shunt feedback
d) Current shunt feedback
8. Which component of Colpitts oscillator is used in feedback system[ ]
a) Inductor
b) Resistor
c) Capacitor
d) Transistor
9. Which of the following network is used to give feedback to transistor[ ]
a) Inductive fixed bias
b) Capacitive fixed bias
c) Inductive voltage divider
d) Capacitive voltage divider
10. What is the reverse transmission factor[ ]
a) Ratio of output by input signal
b) Ratio of feedback by input signal
c) Ration of feedback by output signal
d) Ratio of input by feedback signal
Fill in the Blanks
11. Find the relative change in gain with negative feedback given that return ratio is 24, and feedback
factor is 3, when the change in open loop gain is 2……..
12. Relative change of gain of feedback amplifier is 0.05. Also, loop gain is 9. Find desensitivity…….
13. Circuit P has desensitivity 20, circuit Q has sensitivity 0.1 and circuit R has desensitivity 40. Which of
the following is more stable in gain…….
14. What is a square wave generator…………..
15. Which of these is not a type of monostable multivibrator………….
16. Which of the following are not the characteristics of a crystal oscillator……….
17. Equivalent circuit of crystal oscillator contains ______________
18. The parallel capacitance in the equivalent circuit of crystal oscillator represents __________
19. The inductance in the equivalent circuit of crystal oscillator represents __________
20. The series capacitance in the equivalent circuit of crystal oscillator represents __________