MODEL 6210S IMPACT CAP, MATERIAL:
Ø.500 17-4 PH ST. STEEL, ROCKWELL C44-45
.130 (SUPPLIED)
MODEL 6210A (ALUM ALLOY) ALSO AVAILABLE
1/4-28 TAPPED HOLE,
.175 DEEP, TYP BOTH ENDS
.40
10-32 COAXIAL
CONNECTOR
.625
MODEL 6204 MTG STUD
1/4-28 (SUPPLIED)
2 DRILL NO. 3 (Ø.213) X .250 MIN DEPTH
TAP 1/4-28 UNF-2B X .180 MIN DEPTH
PERFECT THREADS
1 Ø.625 MIN MOUNTING SURFACE
INSTRUMENTS, INC. CHATSWORTH, CA.
EXCEPT AS OTHERWISE NOTED
SCALE REV DATE ECN
3 WRENCH FLATS: 11/16 (.687) ACROSS FLATS X ALL DIMENSI0NS IN INCHES 2X A 5-26-99 -
.31 HIGH. TOLERANCE: .XXX = ± .XX= ±
DATE PART NO.
SURFACE FINISH 1/30/82 -
EXCEPT AS NOTED
2 IT IS IMPORTANT THAT BOTTOM SURFACE OF DRAWN CHECKED MAT'L
SENSOR BE IN INTIMATE CONTACT. INSPECT BREAK EDGES TO DEBURR N.C. N.C. -
FOR BURRS, ETC. RADIUS OR CHAMFER APPROVED NEXT ASSEMBLY USED ON
SERIES 1051V
1 PREPARE FLAT SURFACE OVER Ø.625 MINIMUM TITLE DWG NO.
AREA BY GRINDING, SPOTFACING, LAPPING ETC. - THESE DIAS TO T.I.R.
OUTLINE/INSTALLATION DRAWING,
THIS AREA MUST BE FLAT WITHIS .001 TIR, TYP MODEL 1051V 127-1051V
BOTH MODELS. FILLETS - MAX RAD.
SHEET 1 OF 1
A-Tech Instruments Ltd.
[email protected]; www.a-tech.ca Toronto: 416 754 7008, Montreal: 514 695 5147, Toll Free:1888 754 7008
A-Tech Instruments Ltd.
[email protected]; www.a-tech.ca Toronto: 416 754 7008, Montreal: 514 695 5147, Toll Free:1888 754 7008
