Total No.
of Questions—5
5] [Total No. of Printed Pages—4+2
4+2
Seat
No . [5316]-5
F.Y B.Sc. (Computer Science) EXAMINATION, 2018
ELECTRONIC SCIENCE
Paper I
(ELE-101 : Principles of Analog Electronics)
(2013 PATTERN)
Time : Three Hours Maximum Marks : 80
N.B. :— (i ) All questions are compulsory.
(ii ) Neat diagrams must be drawn wherever necessary.
(iii ) Figures to the right indicate full marks.
1. Attempt all of the following : [8×2=16]
(a) State working principle of transformer.
(b) Draw symbols for photodiode and varactor diode.
(c ) Calculate voltage drop across 2.2 k resistor :
P.T.O.
(d) Define Q point and list the factors affecting stability of the
transistor.
(e) Give sign conventions for Kirchhoff’s voltage law.
(f ) Draw output I-V characteristics of BJT in CE mode and show
all regions in it.
(g) In JFET circuit drain current changes by 20 mA, when V GS
changes by 2 V at a constant drain source voltage. Calculate
drain resistance.
(h) Define the terms differential mode gain and common mode
gain of an op-amp.
2. Attempt any four of the following : [4×4=16]
(a) Explain the classification of capacitors.
(b) Find the value of RL for which maximum power will be transferred
for the following circuit :
[5316]-5 2
(c ) With the help of a neat circuit diagram explain the action
of Zener diode as a regulator.
(d) Explain the frequency response for a single stage R.C. coupled
amplifier.
(e) Explain the working of n-channel JFET with suitable diagram.
(f ) Explain the action of Schmitt trigger using operational
amplifier.
3. Attempt any four of the following : [4×4=16]
(a) Define the following parameters related to operational
amplifiers :
(i ) Output impedance
(ii ) PSRR
(iii ) Output offset voltage
(iv) Input bias current.
(b) Explain the working of MOSFET as a switch.
(c ) Distinguish between JFET and BJT.
(d) Explain the working principle of optocoupler.
(e) Calculate current through load resistor 15 by using Thevenin’s
theorem :
(f ) Explain SPDT and push to ON switch in detail.
[5316]-5 3 P.T.O.
4. Attempt any four of the following : [4×4=16]
(a) Calculate coordinates of d.c. loadline for a silicon transistor
in a circuit :
(b) Define intrinsic stand-off ratio for UJT. Calculate intrinsic stand-
off ratio if RB1 = 6 k , RB2 = 4 k .
(c ) Explain the concept of virtual ground in an op-amp.
(d) State the application of the following types of
transformers :
(i ) Step-up
(ii ) Step-down
(iii ) Isolation
(iv) Centre tapped.
[5316]-5 4
(e) Draw Norton’s equivalent circuit for the following circuit :
(f ) Explain the working of series dipper.
5. Attempt any two of the following : [2×8=16]
(a) (i ) Explain working principle of optical fibre cable.
(ii ) Calculate current through 2 k resistor using Kirchhoff’s
laws :
(b) (i) Distinguish between CB, CE and CC configurations of
transistor.
(ii ) Recognize the application of op-amp and find output voltage
for the following circuits :
(1)
[5316]-5 5 P.T.O.
(2)
(c ) (i ) Define and for transistor. Derive the relation between
and .
(ii ) Derive the expression for discharging current of a
capacitor and plot the graph of discharging current versus
time.
[5316]-5 6
