3/25/24, 3:53 PM SIS 2.
Fuel Transfer Pump - Disassemble (SENR1126-36)
SMCS - 1256 i02055539
Disassembly Procedure
PSP
202 -000A
Start By:
07: 4/03/2 4FC7
a. Remove the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump -
Remove".
5
SEN 3:44+ 5
NOTICE
© 2 R112 08:00
Keep all parts clean from contaminants.
024 6
Contaminants may cause rapid wear and shortened component
life.
Cat
erp
illa
Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior
r In
of the components should be thoroughly cleaned. This will help to prevent dirt from entering the
internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform
c.
disassembly procedures on a clean work surface. Keep components covered and protected at all
times.
Illustration 1 g00918544
1. Pull drive coupling (2) from the drive shaft. Remove O-ring seal (1).
https://sis2.cat.com/#/print-preview/service/bce9aedc-16d9-41e4-a559-212248649262 1/4
3/25/24, 3:53 PM SIS 2.0
Illustration 2 g00918545
Personal injury can result from parts and/or covers under spring
pressure.
Spring force will be released when covers are removed.
Be prepared to hold spring loaded covers as the bolts are
loosened.
2. Remove cap (6), washer (5), valve spring (4), and valve poppet (3).
Illustration 3 g00918549
3. Remove bolts (7). Remove head (8) from plate (9).
https://sis2.cat.com/#/print-preview/service/bce9aedc-16d9-41e4-a559-212248649262 2/4
3/25/24, 3:53 PM SIS 2.0
Illustration 4 g00918554
4. If check valve (10) will be replaced, remove the check valve from head (8).
Illustration 5 g00918555
5. Remove plate (9). Remove gasket (11). Remove the O-ring seal from the side of the plate that
is opposite of gasket (11).
If the bearings in plate (9) are damaged, the plate must be replaced. The bearings are
nonserviceable.
Illustration 6 g00918557
https://sis2.cat.com/#/print-preview/service/bce9aedc-16d9-41e4-a559-212248649262 3/4
3/25/24, 3:53 PM SIS 2.0
6. Remove idler gear (12) and drive shaft (13) from casing (14).
Illustration 7 g00918558
7. Remove casing (14) and sleeves (15) from bracket (16). Remove the O-ring seal from casing
(14).
Illustration 8 g00918559
8. Remove outer lip seal (17) and inner lip seal (18) from bracket (16).
If the bearings in bracket (16) are damaged, the bracket must be replaced. The bearings are
nonserviceable.
PSP-000A4FC7
2024/03/25
07:53:38+08:00
i01762318
© 2024 Caterpillar Inc.
https://sis2.cat.com/#/print-preview/service/bce9aedc-16d9-41e4-a559-212248649262 4/4
