E Series

Eaton E Series DX
20, 30, 40 kVA

Product introduction
The Eaton® E Series DX is a three-phase, double conversion
uninterruptible power supply (UPS), and is available in 20, 30
and 40kVA output power ratings. Its design fits perfectly to any
environment where uninterrupted power feed is required to
secure critical equipment’s continuous operation. The E Series
DX UPS provides a perfect solution for power protection, and
solves power quality problems such as surges, spikes, voltage
fluctuations, harmonic distortion, clutter interference and
frequency fluctuations.
With E series DX, each phase is independently double converted
and regulated. In addition, a PFC (power factor control) controller
is used for real time control and data processing, ensuring high
availability at all times. Further reliability is accomplished by
introducing an intelligent charge mode which significantly prolongs
service life of batteries. The possibility to have dual feed on UPS
input adds availability and increases reliability of the system.
The E-Series DX is available in two cabinet configurations that
accommodate internal/external batteries or external batteries only.
As an added benefit, IP21 compliant design makes E Series
DX a perfect fit for industrial and other applications, with harsh
environmental conditions. An optional filter is also available for
further protection against the smallest damaging particles.

Advanced power protection for:

• IT and networking environments
• wiring closets
• enterprise server applications
• small industrial applications
 N+X redundancy
(supports parallel with the same battery)
More capacity and availability can be achieved by parallel
connection of E Series DX. E Series DX accommodates paralleling
of up to four modules for redundancy or capacity. By incorporating
dual battery feed and advanced battery controls, it can also utilise
common battery for parallel configurations.

Smaller footprint thanks to internal batteries

During power outages and other interruptions, internal batteries
provide emergency power to safeguard operations. Internal
batteries also eliminate the need for costly and space-consuming
external battery cabinets. Eaton E Series DX models that
incorporate internal batteries provide a runtime from 5 to 15
minutes depending on the power rating.

Intelligent battery charge and recharge management

With an intelligent battery management system, charger
parameters can be automatically adjusted based on varying
environmental and load conditions to maximise battery service
life and minimise time required to re-charge. In addition, various
optimised modes are available based on the type and amount of
batteries, providing extended battery life and reducing re-charge
time if additional batteries are added.

Dual feed input

Dual feed input, or dual AC source input, is available with E Series
DX. AC input source is selectable by user based on the installation
requirements.

Communications and remote management

Standard E Series DX models are equipped with an intelligent
communications slot and RS-232 and RS-485 ports. Optional
communications and SNMP/WEB cards are also available to
enable remote monitoring and remote management.

Excellent electrical performance

With total efficiency reaching 92 percent in normal mode,
the E Series DX can achieve up to 98 percent efficiency in high-
efficiency mode, reducing electrical costs and total cost
Rear of 20kVA internal battery model of ownership.
With a wide input voltage range of 210 to 475 Vac, the
E Series DX is able to operate in harsh electrical environments,
providing enhanced availability by utilising intelligent IGBT-based
high-frequency technology to achieve greater than a .99 power
factor. Harmonic distortion is less than five percent.
Providing further peace of mind in harsh electrical environments,
the E Series DX provides enhanced overload protection. In fact,
the E Series DX can operate for ten minutes at a 110 to 125
percent overload and one minute at a 150% overload with short
circuit protection.

SNMP Webpower card

Technical specifications
Input Operation environment
380/400/415 Vac (L-L) Temperature 0°C to 40°C
Nominal Voltage
220/230/240 Vac (L-N) Humidity 20% to 90%
Frequency 40-65 Hz (self-adaptive to 50 Hz and 60 Hz) Efficiency
Wiring 3-Phase + N + PE Line mode 92%
THD i <5% HE (high efficiency) 98%
Power factor >0.99 Display
Dual-line input Supported Chinese/English UPS status and operation
Battery instructions. Input voltage, output voltage, current,
LCD
frequency, charger voltage and current, fault and
Type Maintenance free VRLA batteries
warning display.
Up to 15 min with internal batteries,
Backup time LED UPS operation status
more with external batteries
Warning equipment
360 V (30x12 V, 180 cells),
Battery nominal voltage 20kVA internal battery model Buzzer alarm and light double LED
(lead-acid) 384 V (32x12 V, 192 cells), Communication interface
all other models
RS-232, AS/400, RS485, service, EPO, compensate
Output interface for battery temperature, intelligent slot
380/400/415 Vac (L-L) Compliance with standards
Voltage
220/230/240 Vac (L-N)
Safety (CB certified) IEC62040-1, EN60950-1
Frequency 50/60 Hz
IEC 62040-2, IEC 61000-4-2, IEC 61000-4-3, IEC
EMC
Phase Three-phase four wire + grounding 61000-4-4, IEC 61000-4-5
Power factor 0.8
125%, 10 min.
Overload capability
150%, 1 min.

Description kVA Model description Part number Net weight (kg) Gross weight (kg) Dimensions (WxDxH mm)
Standard models using 20 Eaton E Series DX 20 kVA EDX20K4E 82 122 420 x 643 x 956
external battery solution
30 Eaton E Series DX 30 kVA EDX30K4E 135 210 470 x 710 x 1150
40 Eaton E Series DX 40 kVA EDX40K4E 140 215 470 x 710 x 1150
Standard models with 20 Eaton E Series DX 20 kVA B EDX20K4EB 120 166 420 x 710 x 1245
space for internal
30 Eaton E Series DX 30 kVA B EDX30K4EB 195 255 470 x 710 x 1753
batteries
40 Eaton E Series DX 40 kVA B EDX40K4EB 195 255 470 x 710 x 1753
Standard models with 20 Eaton E Series DX 20 kVA BI EDX20K4EBI 272 320 420 x 710 x 1245
internal batteries installed
30 Eaton E Series DX 30 kVA BI EDX30K4EBI 515 575 470 x 710 x 1753
40 Eaton E Series DX 40 kVA BI EDX40K4EBI 515 575 470 x 710 x 1753

Runtime for UPS with internal batteries p.f. 0.7 (typical IT server/computer load)
Battery Qty 20 30 40 kVA
9 Ah 12 V 2 x 30 10 – – min
9 Ah 12 V 3 x 32 – 10 – min
9 Ah 12 V 4 x 32 – 15 10 min
SINGAPORE INDONESIA THAILAND
Tel : +65 6825 1684 Tel : +62 21 522 6181 Tel : +66 2575 0530
Fax : +65 6825 1689 Fax : +62 21 522 6182 Fax : +66 2575 1579
[email protected]
MALAYSIA VIETNAM
Tel : +603 7804 3618 Tel : +84 4 3936 5303
Fax : +603 7803 6193 Fax : +84 4 3936 5307

Eaton is a trade name, trademark and/or

service mark of Eaton Corporation or its
subsidiaries and affiliates.

® 2008 Eaton Corporation

All Rights Reserved
Printed in Singapore
February 2011