Chassis serial number: 2199691
18-65 Cab tilt system
Description - Cab tilting with electric cab tilt pump
Read through 18-65 Cab tilting > M15, Electric cab tilt pump > Safety – Cab tilt system
before starting work.
Tilt the cab
1. Switch off the engine.
2. Apply the parking brake.
3. Put the gear lever in the neutral position.
4. Remove all loose objects and heavy equipment
from the cab.
5. Activate the switch for cab tilting on the
instrument panel.
357 245
6. Close the doors.
7. Open the upper front grille panel and the front
grille panel side panels.
12/02/2024 (23.50.0.0) [Multi_Authorized_Manager] © Scania CV 1 of 4
Chassis serial number: 2199691
8. Use the remote control for the cab tilting
function under the front grille panel.
358 775
12/02/2024 (23.50.0.0) [Multi_Authorized_Manager] © Scania CV 2 of 4
Chassis serial number: 2199691
9.
WARNING!
2
Do not tilt the cab if the ground slopes more
than 10%. 3 1
390 708
WARNING!
Crew cab and low-entry cab strut
Do not tilt the cab if the anti-roll bar has been
removed.
Depress the activation switch and the tilting
switch, and keep these depressed until the cab
tilts forwards over the equilibrium position.
Continue to keep them depressed until you can
hear the pump working against a back pressure
and the cab has reached its full opening angle.
IMPORTANT!
Continue and keep the button pressed even after
the equilibrium position, until you hear that the
pump is working against a strong back pressure.
10.
IMPORTANT!
Make sure that no unauthorised person has
access to the cab tilting function.
Only crew cab and low-entry cab:
1. Raise the cab strut.
2. Extend the cab strut, until it reaches the
lower part of the cab.
3. Secure the cab strut with the pin.
12/02/2024 (23.50.0.0) [Multi_Authorized_Manager] © Scania CV 3 of 4
Chassis serial number: 2199691
Lower the cab
1. Only crew cab and low-entry cab:
Lower the cab strut.
2. Use the remote control for the cab tilting
function.
3.
WARNING!
Risk of crushing when the cab is tilted back.
The cab falls freely during the last part of the
tilting back phase.
Depress the activation switch and the tilt-back
switch, and keep these depressed until the cab
tilts back to the drive position movement range.
4. Switch off the switch in the cab.
5. Close the front grille panel side panels and the
upper front grille panel.
12/02/2024 (23.50.0.0) [Multi_Authorized_Manager] © Scania CV 4 of 4
