AP63 Hardware Installation Guide
Overview
The Mist AP63 is an IP67 rated outdoor access point which contains three
IEEE 802.11ax radios that deliver 4x4 MIMO with four spatial streams when
operating in multi-user (MU) or single-user (SU) mode.
1Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
I/O ports
100/1000/2500BASE-T RJ45 interface that supports 802.3at/802.3bt
ETH0/PoE IN
PoE PD
ETH1/PSE OUT 10/100/1000BASE-T RJ45 interface + 802.3af PSE (if PoE IN is 802.3bt)
2Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
3Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
AP63 Mounting Kit
Flush Mount Bracket
Articulating Mount Bracket
4Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
5Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
6Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
7Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Technical Specifications:
Feature Description
Power options 802.3at/802.3bt PoE
Dimensions 285mm x 285mm x 85mm (11.2in x 11.2in x 3.3in)
AP63: 3.4 kg (7.48 lbs)
Weight
AP63E: 3.9 kg (8.58 lbs)
Operating AP63 / AP63E : -40° to 65° C without solar loading
temperature AP63 / AP63E: -40° to 55° C with solar loading
Operating humidity 10% to 90% maximum relative humidity, non-condensing
Operating altitude 3,048m (10,000 ft)
Water and Dust IP67
Electromagnetic
FCC Part 15 Class B
emissions
1 – 100/1000/2500BASE-T auto-sensing RJ-45 with PoE
I/O
1 – 10/100/1000BASE-T auto-sensing RJ-45 with PoE out
2.4GHz or 5GHz - 4x4:4SS 802.11ax MU-MIMO & SU-MIMO
5GHz - 4x4:4SS 802.11ax MU-MIMO & SU-MIMO
RF
2.4GHz / 5GHz scanning radio
2.4GHz BLE with Dynamic Antenna Array
Total maximum PHY rate – 4800 Mbps
Maximum PHY rate 5GHz – 2400 Mbps
2.4GHz or 5GHz – 1148 Mbps or 2400Mbps
Indicators Multi-color status LED
Wind Loading Beaufort scale 17
UL 62368-1
CAN/CSA-C22.2 No. 62368-1-14
Compliance standards FCC Part 15.247, 15.407, 15.107, and 15.109
RSS-247
ICES-003:2020 Issue 7, Class B (Canada)
8Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Warranty Information
The AP63 family of Access Points come with a 1 year limited warranty.
Ordering Information:
Access Points
AP63-US 802.11ax 4+4 Outdoor and BLE AP – Internal Antenna
for the US Regulatory domain
AP63E-US 802.11ax 4+4 Outdoor and BLE AP – External Antenna
for the US Regulatory domain
AP63-WW 802.11ax 4+4 Outdoor and BLE AP – Internal Antenna
for the WW Regulatory domain
AP63E-WW 802.11ax 4+4 Outdoor and BLE AP – External Antenna
for the WW Regulatory domain
Mounting brackets
APOUTBR-KIT APOUTBR-FM and APOUTBR-ART2
APOUTBR-FM Flush mount for Outdoor AP
APOUTBR-ART2 Articulating mount for Outdoor AP
9Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Regulatory Compliance Information:
If you need further assistance with purchasing the power source, please contact Juniper
Networks, Inc.
10Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
FCC Requirement for Operation in the United States of
America:
FCC Guideline for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 31
cm between the radiator & your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
● Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
● This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
● It must be Professionally installed.
11Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Industry Canada
This device complies with RSS-247 of the Industry Canada Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Ce dispositif est conforme à la norme CNR-247 d'Industrie Canada applicable aux appareils
radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1)
le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 36
cm between the radiator & your body.
Déclaration d'exposition aux radiations:Cet équipement est conforme aux limites
d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 36 cm de distance entre la
source de rayonnement et votre corps.
IC Caution
This radio transmitter (IC: 22068-AP63 / Model: AP63, AP63E) has been approved by
Innovation, Science, and Economic Development Canada to operate with the antenna
types listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated for any type
listed are strictly prohibited for use with this device.
The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-
5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit.
The maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be
such that the equipment still complies with the e.i.r.p. limits specified for point-to-point
and non-point-to-point operation as appropriate.
Avertissement
Le présent émetteur radio (IC: 22068-AP63 / Model: AP63, AP63E) a été approuvé par
Innovation, Sciences et Développement économique Canada pour fonctionner avec les
types d'antenne énumérés ci-dessous et ayant un gain admissible maximal d'antenne. Les
types d'antennes non inclus dans cette liste qui ont un gain supérieur au gain maximal
indiqué pour tout type listé sont strictement interdits pour une utilisation avec cet appareil.
Le gain maximal d'antenne permis pour les dispositifs utilisant les bandes de 5250 à 5
12Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
350 MHz et de 5470 à 5725 MHz doit être conforme à la limite de la p.i.r.e.
Le gain maximal d'antenne permis (pour les dispositifs utilisant la bande de 5 725 à 5 850
MHz) doit être conforme à
la limite de la p.i.r.e. spécifiée pour l'exploitation point à point et l’exploitation non point à
point, selon le cas.
Approved antenna(s) list:
AP63:
Ant Brand Model Name Antenna Antenna Gain (dBi) Radio
Type WLAN WLAN Bluetooth
2.4GHz 5GHz
1~ Juniper PIFA - 6 - 5GHz
81XKAF15,G35
4
5~ Juniper PIFA 4 - - 2.4GHz
81XKAF15,G35
8
9 Juniper 81XKAF15,G35 PIFA 2.3 4.7 - 2.4GHz/5GHz
10 Juniper 81XKAF15,G35 PIFA 2.3 4.7 - 2.4GHz/5GHz
11 Juniper PIFA - - 5.1 BT
~ 81XKAF15,G35
18
19 Juniper 81XKAF15,G35 PIFA - - 4.3 BT
20 Juniper 81XKAF15,G35 PIFA - - 1.4 BT
AP63E:
Ant Port Brand Model Name Antenna Antenna Gain (dBi) Radio
Type WLAN WLAN Bluetooth
2.4GHz 5GHz
1 1~ Acceltex ATS-OO-245- Omni 4 6 - 2.4GHz/5GHz
6 46-6NP-36
2 1~ Acceltex ATS-OP-245- Patch 8 10 - 2.4GHz/5GHz
6 810-6NP-36
3~ Juniper PIFA - - 5.1 BT
81XKAF15,G35
10
11 Juniper 81XKAF15,G35 PIFA - - 4.3 BT
12 Juniper 81XKAF15,G35 PIFA - - 1.4 BT
13Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
CE
This device complies with the Radio Equipment Directive, 2014/53/EU, issued by the
Commission of the European Community.
Hereby, Juniper Networks, Inc. declares that the radio equipment type (AP63) is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following:
https://www.mist.com/support/
The frequency and maximum EIRP Power in EU:
Bluetooth:
Frequency range (MHz) Maximum EIRP in EU (dBm)
2400 – 2483.5 8.19
WLAN:
Frequency range Maximum EIRP in EU Maximum EIRP in EU Maximum EIRP in EU
(MHz) (dBm) – Ext. Omni (dBm) – Ext. Patch (dBm) – Int. PIFA
2400 – 2483.5 19.99 19.99 19.99
5470 – 5725 29.99 29.99 29.99
5725 – 5850 13.94 13.95 13.97
The minimum distance between the user or bystander and the radiating structure of the
transmitter is 20 cm.
The product is for use by authorized professionals and in environments where the product
has been assessed for safe and compliant operation. The installer is responsible for
ensuring that the equipment meets all local safety requirements for the installed location.
For products not certified for use in Hazardous Locations, the equipment is not suitable for
use in explosive environments, in the presence of flammable liquids, near explosives, or in
areas where blasting is occurring.
14Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Oman
Thailand
• ่
เครืองโทรคมนาคมและอุ ้ ความสอดคล ้องตามมาตรฐานหรือข ้อกําหนดทางเทคนิ คของ กสทช.
ปกรณ์นีมี
Belarus
South Korea
해당 무선설비는 운용 중 전파혼신 가능성이 있음
15Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Morocco
Mexico
• La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es
posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este
equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operación no deseada
• Este equipo ha sido diseñado para operar con las antenas que enseguida se enlistan
y para una ganancia máxima de antena de [8dBi por 2.4GHz y 10dBi por 5GHz]. El
uso con este equipo de antenas no incluidas en esta lista o que tengan una ganancia
mayor que [8dBi por 2.4GHz y 10dBi por 5GHz] quedan prohibidas. La impedancia
requerida de la antena es de [50] ohms
16Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Ukraine
17Juniper Public
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
